Hobart HBR300 instruction manual Tip, Look At This

Page 6

Bench Receiving Scale

Installation and Setup by an Authorized Hobart Technician

Manual Overview

☛

Before using your scale for the first time, an Authorized Hobart Service Technician must install and set up your scale. This includes:

¥Mounting the display and display pole to the platform.

¥Setting an automatic shut off time as an energy saver to extend battery life.

¥Calibrating your scale.

The following special instructions are used in the manual:

Note

A note is information that you need to know, but it is not an actual step in the procedures.

✎

Tip

A tip is additional information that may be useful when you are using the system.

Look At This

Look At This is information to alert you that you may be doing something that will permanently alter your system.

2

Page 5 Page 7
Image 6
Page 5 Page 7
Contents HBR300 Bench Receiving Scale Page Table of Contents Page Verify Correctness of Weight IntroductionFCC Note Tip Look At ThisUsing the Scale DonõtSupplying Power to the Scale Adjusting the Display Head for Easy Viewing Leveling the ScaleDisplay Indicator Illuminated Arrow IndicatesDisplay Head OverOperator Mode KeypadSetup Mode Key FunctionOperating in Setup Mode Presetting TareOperating the Scale Press Clearing a Preset Tare Setting Upper and LowerWeight Limits Press Clearing Upper and Lower Weighing a Product When Operating in Operator ModeUpper and Lower Weight Limits Are SetCleaning and Maintaining the Scale CleaningWeighing in Batches Sanitizing MaintainingDon’t Error Messages Error Message Possible Cause ActionAccessory Mobile Cart Page 34220 Rev. a 2/99
Top Page Image Contents