Panasonic MC-UG787 manuel dutilisation Removing Clogs

Page 44

Removing Clogs

Clean Out Port

Sortie de

nettoyage

(Clean Out Port)

Cubierta de salida

(Clean Our Port)

Nozzle Hose

Tuyau de tête

d'aspiration

Manguera de

Boquilla

Body Hose

Tuyau

Manguera

Hose Inlet

Entrée du tuyau Conección de manguera

The body hose located on the back of the vacuum cleaner carries the dirt from the nozzle up to the dust bag. If the hose should become clogged:

Unplug vacuum cleaner.

Pull open CLEAN OUT PORT and check for clogging. Secure suction inlet cover properly after checking.

Disconnect body hose from wand holder and check hose ends.

Plug in vacuum cleaner and turn on.

Stretch body hose in and out to remove clogs that may not be seen.

If clog still exists, turn vacuum cleaner OFF and UNPLUG POWER CORD.

Remove lower plate. See: “Removing and Installing Lower Plate”

Inspect inlet of nozzle hose and clear any obstructions.

- 44 -

Image 44
Contents MC-UG787 Consumer Information Avertissement Advertencia Cuidado Important Safety Instructions Avertissement Advertencia Table of Contents Table des matières Tabla de contenidoParts Identification Feature Chart Tableau des caractéristiquesPower Cord Attaching HandleMontage du manche Colocación del mangoCordon d’alimentation Cordón eléctricoTool Storage Rangement des accessoires Almacenaje de herramientasCarpet/Floor Selector Automatic Self Adjusting NozzleEdge Cleaning Limpieza para orillas Boquilla de ajuste automáticoSelector alfombra-piso Performance Indicator Dirt SensorIndicateur de performance Indicador del funcionamientoDétecteur de poussière Sensor de basuraOverload Protection Thermal ProtectorProtecteur de surcharge Protector contra sobrecargasProtecteur thermique Protector termalMotor Protector Extension WandProtecteur du moteur Protector de motorTube Télescopique Tubo TelescópicoTo Operate Vacuum Cleaner Power Cord Using Cord HookCrochet de rangement du cordon Uso del sujetador del cordónON-OFF Switch Handle AdjustmentInterrupteur Control ON-OFFRéglage de l’inclinaison du boîtier Ajustes del mangoUsing Tools Utilisation des accessoires Uso de herramientasReplacing Hepa Filter Replacing Secondary FilterRemplacement du filtre De type Hepa Remplacement du filtre SecondaireCambiando el filtro Hepa Cambiando el filtro secundarioChanging Dust Bag Remplacement du sac à poussière Cambio de la bolsa para polvoRemoving and Installing Lower Plate Enlèvement et installation de la Plaque inférieure Remover y reinstalar la base inferiorReplacing Headlight Bulb Remplacement de l’ampoule De la lampe Cambio de la bombillaReplacing Belt Remplacement de la courroie Cambio de la correaCleaning Dirt Sensor Optics Nettoyage des cellules optiques du Détecteur de poussière Para limpiar la basura de la óptica del sensorCleaning Agitator Cleaning Exterior and ToolsNettoyage du boîtier et des accessoires Nettoyage de l’agitateurLimpieza del agitador Limpieza del exterior y de las HerramientasRemoving Clogs Dégagement des obstructions Limpiar los residuos de basura en los conductosBefore Requesting Service Guide de dépannage Antes de pedir servicio Warranty Panasonic Platinum Series Vacuum Cleaner Limited WarrantyLimitations and Exclusions Garantie Garantía Page Page Page What to do When Service is Needed