Manual cleaning
The
Rinsing the shaving head under running water is an alternative way to keep the shaver clean, especially when travelling:
•Switch the shaver on (cordless) w and rinse the shaving head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•Next, switch off the shaver, press the release button 9 to remove the foil and cutter cassette 8 and let it dry.
•If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the foil and cutter cassette.
Alternatively, you may clean the shaver using the brush provided:
•Switch off the shaver. Remove the foil and cutter cassette 8 and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. However, do not clean the cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button 2 to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
trim |
mer |
on |
Series | Series |
release |
|
er |
oil |
Series 7 |
release |
click! |
Series 7 |
release |
trimmer |
Series 7 |
release |
| Series 7 |
release | release |
new |
| old |
| ||
|
11