Maintenance and Lubrication Schedule
continued
Perform all procedures listed in previous section also
1500
Cycles
Rotating pivot slide arm pivot pins (2)
Parallel arm pivot bearings (16)
Handrail pivot pin bearings (4)
Hydraulic cylinder bushings (8)
Inspect
Inspect outer barrier feet for proper operation, positive securement and detached or missing tor- sion spring
Inspect inner roll stop for:
•Wear or damage
•Proper operation. Roll stop should just rest on top surface of the threshold (base) plate.
•Positive securement (both ends)
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace damaged parts and/or relubri- cate.
Correct, replace damaged parts and/or relubri- cate.
Resecure, replace or correct as needed. See Platform Angle Instructions and Floor Level Adjustment Instructions.
Inspect handrail components for wear or damage, | Replace damaged parts. |
and for proper operation |
|
Page 46