Maintenance and Lubrication Schedule
750
Cycles
Inspect inner roll stop and linkage for:
•Proper operation. Roll stop should rest solidly on floor providing smooth transition.
•Positive securement
•Wear or damage
Check carriage ride height in housing
Check stow height/lifting arm alignment
Inspect wiring harnesses for securement, wear or other damage
Check lower pan securement
Torque tube pivot bearings (4 places)
Resecure, replace or correct as needed. See Inner Roll Stop Adjustment Instructions.
Adjust as needed. See Carriage Ride Height Adjust- ment.
Lifting arms should be horizontal, aligned with each other and aligned with carriage. Adjust as needed. See Switch Adjustment (Below Stow Switch).
Resecure, replace or correct as needed
Resecure, replace damaged parts or correct as needed.
Apply Light Oil - See Lubrication Diagram
1500
Cycles
Perform all procedures listed in previous section also
Carriage and eccentric shaft rollers (bearings) | Apply Light Oil - See Lubrication Diagram |
Page 44