Mitel 5700 manual Destination directory number, Forward if Busy

Page 18

Chapter 4 Call Forward

4.2Setting Call Forward in Other H.323 Videoconferencing Applications

In 5760 VCA and other H.323 videoconferencing applications, you can enable Call Forwarding by dialing a code. If you do not know the code, ask the system administrator.

!To set Call Forward

1.Open your application’s Dialing utility.

2.Dial one of the following (bold values are factory defaults):

For this feature

Dial this number

Forward if No

*70 (or other code number) followed by [other

Answer

destination directory number]

 

Activate if you want to forward calls intended for you to

 

another user. The interval before transferring the call is

 

set by the system adminstrator.

 

For example, *70751will forward calls to user 751.

Forward if Busy

*71 (or other code number) followed by [other

 

destination directory number]

 

Activate if you want to forward calls to another user if

 

you are engaged in another videoconference.

 

For example, *71751will forward calls to user 751.

Unconditional

*72 (or other code number) followed by [other

forwarding

destination directory number]

 

Activate if you want to forward all calls intended for

 

you to another user.

 

For example, *72751will forward calls to user 751.

NOTE After dialing, a “Call Rejected” message appears. However, the request is accepted by the 5700 VFA if the dialed number is valid.

12

Mitel Networks 5700 VFA End Point’s Guide

 

 

Page 17 Page 19
Image 18
Page 17 Page 19
Contents
End Points Guide Trademarks Limited Warranty Product Names Table of Contents Page Telephony Exchange in Videoconferences Page Registration by a MeetingPoint 4.6 or Higher User Initial Login to 5700 VFARegistering to the 5700 VFA To log in to the 5700 VFARegistration by a 5760 VCA User VCA Main Menu323 Tab Registration by Other H.323 Videoconferencing User Calling Other Videoconferencing Users Videoconferencing in Non-Voice First ModeTo place a call using a 5020/5220 IP Phone Voice First Mode Videoconferencing with 5020/5220 IP PhonesTo call another registered user Setting Call Forward in MeetingPoint Call ForwardTo set Call Forward Call Forward Calls Properties Are engaged in another videoconference Select if you want to forward ALL calls intended forYou to another user Select if you want to forward calls intended for you toDestination directory number Forward if Busy70* or other code number To disable Call ForwardEntering a Call Forwarding Dialing Code 71* or other code numberCall Forward Mitel Networks 5700 VFA End Point’s Guide Call Pickup Call Pickup in MeetingPoint To pick up a call to a specific userPick Up Specific Call Dialog Box To pick up any ringing call Incoming CallCall Pickup in Other H.323 Videoconferencing Applications To transfer a call to another user Call TransferCall Transfer in MeetingPoint Transfer Dialog BoxCall Transfer in 5760 VCA Call Transfer in Other H.323 Videoconferencing Applications Call Transfer Mitel Networks 5700 VFA End Point’s Guide Inviting Additional Users from MeetingPoint AD-HOC ConferencingInviting Additional Users with 5020/5220 IP Phones Inviting Users from MeetingPointInviting Additional Users from 5760 VCA Inviting Users from 5760 VCAAd-Hoc Conferencing Page Starting a Call Through a Gateway To start a LAN-to-ISDN call through a gatewayPage Connecting to AN MCU Videoconference To dial a videoconference through an MCU