Radio Shack TAD-729 owner manual Setting the Dialing Mode

Page 11

Recharge the battery pack when Low Battery flashes on the display.

Important: Be sure the battery pack is properly connected before you try to charge it. The CHARGE/IN USE indica- tor lights when the handset is on the base, even if the battery pack is not con- nected.

Notes:

When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear a five-beep error sig- nal. If this happens, return the hand- set to the base for about 5 seconds. This resets the security access-pro- tection code.

Using a pencil eraser, clean the charging contacts on the handset and the base about once a month.

If the display is blank and the phone does not work, recharge the battery pack. (The battery power might be too low to light the display.)

If the battery pack becomes weak during a call, the handset beeps every 3 seconds and Low Bat- tery flashes. When this happens, you cannot make another call on the phone until you recharge the battery pack.

About once a month, fully discharge the battery pack by keeping the handset off the base until Low Battery flashes. Otherwise, the battery pack loses its ability to fully recharge.

If the battery pack is completely dis- charged or the base loses power while the handset is away from it, place the handset on the base to reset the security access-protection code. If it was the handset that lost power, recharge the battery pack.

The supplied battery pack should last about a year. When it loses its ability to fully recharge, order a replacement battery pack through your local RadioShack store (see “Replacing the Battery Pack” on Page 37).

SETTING THE DIALING MODE

Set DIAL MODE on the back of the base for the type of service you have. If you are not sure which type you have, after you charge the handset battery pack, do this simple test.

11

Image 11
Contents TAD-729 Features Telephone Features Important Caller ID Information TAD FeaturesFCC Statement Read this Before InstallationContents Using the Toll-Saver Using Remote Commands On a Desk Top PreparationMounting the Phone On a Wall Plate or Wall Connecting and Charging the Battery Pack Setting the Dialing Mode Turning the BASE’S Ringer OFF and on Setting the Ringer TONE/VOLUMESetting the DAY/TIME Setting the Number of RingsStoring Your Area Code Setting Auto TalkTurning Call WAITING/ Caller ID ON/OFF Page Making and Receiving a Call Using the HandsetUsing the Speakerphone Telephone OperationUsing Both Handset Speakerphone Adjusting Handset VolumeUsing Mute Switching Between the Handset and SpeakerphoneUsing Redial Using FlashTransferring a Call Between the Handset and Base Using PAGE/INTERCOMUsing a Headset Handset Memory DialingStoring a Name and Number in Memory Base Reviewing Memory Numbers Handset only Editing or Deleting a Number in the HANDSET’S MemoryEntering a Pause Dialing a Memory Number CHAIN-DIALING Service NumbersTesting Stored Emergency Numbers Caller ID Messages Caller ID Operation Handset onlyReviewing Caller ID Records Deleting Caller ID Records Storing a Caller ID Record to MemoryPage RECORDING/DELETING AN Outgoing Message Setting the Record TimeTAD Operation Recording a Memo Setting the TAD to Answer CallsScreening Calls Recording Incoming MessagesPlaying Messages Recording a ConversationDeleting Messages Adjusting the TAD’S VolumeRemote Operation Using the TOLL-SAVERUsing Remote Commands Press # then Problem Suggestion TroubleshootingProblem Suggestion Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowPage RadioShack Corporation