Radio Shack TAD-729 owner manual Problem Suggestion

Problem	Suggestion
The handset stops working or	Move the handset closer to the base.
works poorly during a call.
	Lift the base’s antenna to a vertical position.
	Be sure the battery pack is charged. (If the battery
	power is too low, it does not have enough power to light
	the display.)
	If the base loses power while the handset is away, the
	security access-protection code might change. Restore
	power to the base, then place the handset back on the
	base. The CHARGE/IN USE indicator lights, indicating
	that the code is set again.
	Check the charging contacts on the handset and base. If
	they are dirty, clean them with a pencil eraser.
The TAD does not answer calls.	Make sure the TAD is turned on.
	Make sure the AC adapter is properly connected.
	Check all phone line connections.
The TAD does not record call-	REC TIME is set to ANN (announcement only). Set it to 1
ers’ messages.	or 4.
	Delete messages if memory is full.
Low Battery flashes on the	Be sure the battery pack is correctly connected.
display every few seconds.
You have an incoming call, but	Let the phone ring twice before you answer so the sys-
do not receive any Caller ID	tem has time to record the Caller ID information.
information.
	Check that the system is correctly and securely con-
	nected.
	Call your phone company to verify that your Caller ID
	service is active.

If you still have problems, disconnect the TAD-729. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.

35