Radio Shack TAD-729 owner manual Connecting and Charging the Battery Pack

Page 10

Note: To mount the TAD directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base. Follow the steps under “On a Wall Plate or Wall” on Page 9, then apply these additional in- structions for placement on a wall.

1. Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 5/16 inch (8 mm) from the wall.

2.Plug one end of the supplied long modular cord into the TEL LINE jack at the back of the base.

3.Align the bracket’s keyhole slots with the mounting screws and slide the base downward to secure it.

CONNECTING AND CHARGING THE BATTERY PACK

The TAD-729 comes with a recharge- able nickel-cadmium battery pack in- stalled in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 24 hours.

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the com- partment. Plug the battery pack’s connector into the socket in the compartment. The connector fits only one way.

3.Put the battery pack in the compart- ment.

4.Replace the cover.

To charge the battery pack, simply place the handset on the base, facing either up or down. The CHARGE/IN USE indi- cator on the base lights.

10

Image 10
Contents TAD-729 Features Telephone Features TAD Features Important Caller ID InformationRead this Before Installation FCC StatementContents Using the Toll-Saver Using Remote Commands Mounting the Phone PreparationOn a Desk Top On a Wall Plate or Wall Connecting and Charging the Battery Pack Setting the Dialing Mode Setting the Ringer TONE/VOLUME Turning the BASE’S Ringer OFF and onSetting the Number of Rings Setting the DAY/TIMETurning Call WAITING/ Caller ID ON/OFF Setting Auto TalkStoring Your Area Code Page Telephone Operation Using the HandsetUsing the Speakerphone Making and Receiving a CallSwitching Between the Handset and Speakerphone Adjusting Handset VolumeUsing Mute Using Both Handset SpeakerphoneUsing Flash Using RedialUsing PAGE/INTERCOM Transferring a Call Between the Handset and BaseUsing a Headset Storing a Name and Number in Memory Memory DialingHandset Base Entering a Pause Editing or Deleting a Number in the HANDSET’S MemoryReviewing Memory Numbers Handset only Testing Stored Emergency Numbers CHAIN-DIALING Service NumbersDialing a Memory Number Reviewing Caller ID Records Caller ID Operation Handset onlyCaller ID Messages Storing a Caller ID Record to Memory Deleting Caller ID RecordsPage TAD Operation Setting the Record TimeRECORDING/DELETING AN Outgoing Message Recording Incoming Messages Setting the TAD to Answer CallsScreening Calls Recording a MemoRecording a Conversation Playing MessagesAdjusting the TAD’S Volume Deleting MessagesUsing Remote Commands Using the TOLL-SAVERRemote Operation Press # then Troubleshooting Problem SuggestionProblem Suggestion Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know LightningPage RadioShack Corporation