Radio Shack TAD-729 owner manual Recording a Conversation, Playing Messages

Page 30

To record a memo, hold down MEMO on the base until the TAD beeps and ––appears in the message counter win- dow, then speak your message. When you finish the memo, press PLAY/STOP or MEMO.

PLAY/STOP

To stop recording, press PLAY/STOP or MEMO. The TAD-729 stores a recorded conversation as a message (see “Play- ing Messages”).

Note: The TAD-729 cannot record a conversation less than two seconds long, or a call using the speakerphone.

MEMO

Note: The TAD-729 cannot record a memo less than two seconds long.

RECORDING A

CONVERSATION

The TAD-729 lets you record both sides of a telephone conversation when you are talking with the handset.

Important Note: It is illegal in some ar- eas to record a conversation without the consent of all parties to the conversa- tion, including the phone company. Check the laws in your area before you use the two-way recording feature.

To start recording a phone conversation, hold down MEMO on the base until the TAD beeps and ––appears.

PLAYING MESSAGES

After the TAD-729 has recorded a mes- sage, its message counter shows the to- tal number of messages stored. If you have new messages, the number flash- es. To play your messages, press PLAY/ STOP. The TAD announces the number of new and old messages, then plays the new messages. The message num- ber appears as each message plays, and the TAD announces the day and time of the call at the end of each mes- sage.

To play all messages after playing the new messages, press PLAY/STOP again. To skip to the next message, press SKIP during playback.

To replay the current message from the beginning, press REPEAT. If you press REPEAT within about 4 seconds after a message begins playing, the TAD re- plays the previous message.

30

Image 30
Contents TAD-729 Features Telephone Features TAD Features Important Caller ID InformationRead this Before Installation FCC StatementContents Using the Toll-Saver Using Remote Commands Preparation Mounting the PhoneOn a Desk Top On a Wall Plate or Wall Connecting and Charging the Battery Pack Setting the Dialing Mode Setting the Ringer TONE/VOLUME Turning the BASE’S Ringer OFF and onSetting the Number of Rings Setting the DAY/TIMESetting Auto Talk Turning Call WAITING/ Caller ID ON/OFFStoring Your Area Code Page Telephone Operation Using the HandsetUsing the Speakerphone Making and Receiving a CallSwitching Between the Handset and Speakerphone Adjusting Handset VolumeUsing Mute Using Both Handset SpeakerphoneUsing Flash Using RedialUsing PAGE/INTERCOM Transferring a Call Between the Handset and BaseUsing a Headset Memory Dialing Storing a Name and Number in MemoryHandset Base Editing or Deleting a Number in the HANDSET’S Memory Entering a PauseReviewing Memory Numbers Handset only CHAIN-DIALING Service Numbers Testing Stored Emergency NumbersDialing a Memory Number Caller ID Operation Handset only Reviewing Caller ID RecordsCaller ID Messages Storing a Caller ID Record to Memory Deleting Caller ID RecordsPage Setting the Record Time TAD OperationRECORDING/DELETING AN Outgoing Message Recording Incoming Messages Setting the TAD to Answer CallsScreening Calls Recording a MemoRecording a Conversation Playing MessagesAdjusting the TAD’S Volume Deleting MessagesUsing the TOLL-SAVER Using Remote CommandsRemote Operation Press # then Troubleshooting Problem SuggestionProblem Suggestion Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know LightningPage RadioShack Corporation