Radio Shack TAD-729 owner manual Adjusting the TAD’S Volume, Deleting Messages

Page 31

ADJUSTING THE TAD’S VOLUME

To adjust the speaker’s volume, repeat-

edly press VOL or on the base. The volume setting from 1 (lowest) to 10 (highest) appears in the message counter window.

DELETING MESSAGES

To delete the current message while it is playing, hold down DELETE until the TAD beeps.

DELETE PIN

To delete all messages at once, while messages are not playing, hold down DELETE on the base until the TAD beeps and 0 appears in the message counter window.

Note: You cannot delete new (not yet played) messages. If you try to delete all messages at once while you still have new messages, the TAD sounds five quick beeps and does not delete any messages.

SETTING THE REMOTE OPERATION PIN

The TAD-729’s two-digit remote opera- tion PIN (personal identification number) prevents unauthorized remote access to your messages. The PIN is preset to 80.

Follow these steps to change the PIN to any number from 00 to 99.

Note: If you wait more than 2 minutes between each keypress, the TAD exits the PIN setting process. Start again at Step 1.

1.Hold down PIN until the TAD beeps and 00 appears in the message counter window.

2.Press SKIP to set the first digit of the PIN higher or REPEAT to set it lower. Then press PIN.

3.Press SKIP or REPEAT to set the second digit of the PIN, then press PIN. The TAD announces the new PIN.

To check your PIN at any time, press PIN. The PIN appears in the message counter window, and the TAD announc- es it.

Note: If you press SPEAKER or PLAY/ STOP while changing the PIN, the TAD exits. Begin again with Step 1.

31

Image 31
Contents TAD-729 Features Telephone Features Important Caller ID Information TAD FeaturesFCC Statement Read this Before InstallationContents Using the Toll-Saver Using Remote Commands Mounting the Phone PreparationOn a Desk Top On a Wall Plate or Wall Connecting and Charging the Battery Pack Setting the Dialing Mode Turning the BASE’S Ringer OFF and on Setting the Ringer TONE/VOLUMESetting the DAY/TIME Setting the Number of RingsTurning Call WAITING/ Caller ID ON/OFF Setting Auto TalkStoring Your Area Code Page Making and Receiving a Call Using the HandsetUsing the Speakerphone Telephone OperationUsing Both Handset Speakerphone Adjusting Handset VolumeUsing Mute Switching Between the Handset and SpeakerphoneUsing Redial Using FlashTransferring a Call Between the Handset and Base Using PAGE/INTERCOMUsing a Headset Storing a Name and Number in Memory Memory DialingHandset Base Entering a Pause Editing or Deleting a Number in the HANDSET’S MemoryReviewing Memory Numbers Handset only Testing Stored Emergency Numbers CHAIN-DIALING Service NumbersDialing a Memory Number Reviewing Caller ID Records Caller ID Operation Handset onlyCaller ID Messages Deleting Caller ID Records Storing a Caller ID Record to MemoryPage TAD Operation Setting the Record TimeRECORDING/DELETING AN Outgoing Message Recording a Memo Setting the TAD to Answer CallsScreening Calls Recording Incoming MessagesPlaying Messages Recording a ConversationDeleting Messages Adjusting the TAD’S VolumeUsing Remote Commands Using the TOLL-SAVERRemote Operation Press # then Problem Suggestion TroubleshootingProblem Suggestion Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowPage RadioShack Corporation