Sanyo CLT-J30 instruction manual Changing the Battery, Battery replacement and handling

Page 23

CHANGING THE BATTERY

Battery replacement and handling

When the operating time becomes short even after a battery is recharged, please replace the battery.

With normal usage, your battery should last about one year.

For a replacement battery, please contact your place of purchase or fill out and mail the enclosed form.

Caution:

Use only the specified battery type (3.6V, 600mAh).

Do not remove the battery from the handset to charge it.

Never throw the battery into a fire, disassemble it, or heat it.

Do not remove or damage the battery casing.

Remove battery if storing the phone for over 30 days.

Make sure the telephone is off before you replace the battery.

1.Slide off the battery compartment cover.

2.Disconnect the battery plug from the jack in the compartment and remove the battery pack.

3.Insert the new battery pack and connect the cord into the jack.

Note: Please refer to the pictures on page 6, “Battery setup” for guide.

4.Put the battery compartment cover back on.

5.Place handset on the base to charge for 12 hours.

Note: If the handset battery is removed for more than 5 minutes, the directory memory and caller ID memory will be erased.

Charge the handset battery for 12 hours continuous prior to first use. The initial battery charge is important for best performance.

Caution: To reduce the risk of fire or personal injury, use a 3.6 V, 600mAh battery.

Replacement part number: GES-PC3F03.

23

Image 23
Contents Sanyo Canada Inc CLT-J30Table of Contents Recycling NICKEL-METAL Hydride Batteries Compander Plus Noise Reduction Main Features GHz TechnologyOther features IntroductionModular jack Checking package contentsGetting Started Telephone line connection Battery setupTone/pulse setting Digital Security System Mounting on a wallHandset Names and ControlsBase Unit Press FLASH/PROG until 1 ENG 2 FRA 3 ESP shows on screen Language settingArea code setting Initial ProgrammingLCD contrast DND settingIdle animation Resetting to defaultReceiving a call Volume adjustmentRinger switch BasicsFast redialing Press TALK/CALL Back Pre-dialing up to 32 digitsPress TALK/CALL Back Changing the pre-dial number RedialingMute key Low battery warningVoice mail indicator Handset locator Paging functionCaller ID list Caller ID FeaturesCaller ID with Call Waiting Storing Caller ID entries in the directory Reviewing Caller ID listFormat Caller ID numbers Dialing a Caller ID number Deleting all entries Deleting entries from the Caller listDeleting the displayed entry Store a number in the directory DirectoryMaking calls from the directory Replacing a directory entry with a Caller ID entryChanging a stored number Number for Memory Location Reviewing and deleting directory contentsChain dialing from the directory Battery replacement and handling Changing the BatteryRecycling NICKEL-METAL Hydride Batteries Power FailureChanging the Face Plates Headset Jack and Belt Clip Light SignalsLCD Screen Messages ErrorNo display Sound SignalsTroubleshooting Caller ID error messagePhone beeps Dial tone is OK, but cannot dial outHandset does not ring You experience static, noise, or fading in and outCauses of poor reception MaintenanceCharge it for a full 12 hours Maximize Battery PerformanceKeep the contacts clean Refresh batteryTechnical Information Technical Information What is not Covered Sanyo Comfort WarrantyBetween 830 am 700 pm EST SOS Help Line