Sanyo CLT-J30 Maximize Battery Performance, Charge it for a full 12 hours, Refresh battery

Page 30

MAXIMIZE BATTERY PERFORMANCE

The freedom that your cordless telephone can offer is fully dependent on the performance of the rechargeable battery in the handset. To maximize the battery performance, follow these guidelines:

Charge it for a full 12 hours

Before initial use of your new battery, charge it for 12 hours continuously. The proper initial charging is very important to maximize the battery performance.

Keep the contacts clean

You can never fully recharge the battery if the contacts are dirty. Clean all the contacts - two at the bottom of the handset and two in the base cradle - periodically, using a pencil eraser.

Do not replace the handset in the base after each call

Repeated short charging creates a memory effect in the battery. Once a rechargeable battery acquires this “short memory”, it sends a “low battery” signal even when it is almost fully charged. The battery then needs to be charged frequently. To avoid this, leave the handset away from the cradle until it really needs recharging.

Refresh battery

If your battery seems to need recharging more often than usual, it may have lost part of its charging capacity because of premature recharges. To bring back its full capacity, try “refreshing” the battery:

1.First discharge the battery by leaving the handset in TALK mode until Battery Low indication turns on. (Disconnect the base from the telephone line, so that your line is not busy all the time.)

2.Then charge it for 12 continuous hours.

3.Repeat the above once more.

30

Image 30
Contents CLT-J30 Sanyo Canada IncTable of Contents Recycling NICKEL-METAL Hydride Batteries Introduction Main Features GHz TechnologyOther features Compander Plus Noise ReductionChecking package contents Getting StartedModular jack Battery setup Tone/pulse settingTelephone line connection Mounting on a wall Digital Security SystemNames and Controls HandsetBase Unit Initial Programming Language settingArea code setting Press FLASH/PROG until 1 ENG 2 FRA 3 ESP shows on screenDND setting LCD contrastResetting to default Idle animationBasics Volume adjustmentRinger switch Receiving a callRedialing Pre-dialing up to 32 digitsPress TALK/CALL Back Changing the pre-dial number Fast redialing Press TALK/CALL BackHandset locator Paging function Low battery warningVoice mail indicator Mute keyCaller ID Features Caller ID with Call WaitingCaller ID list Reviewing Caller ID list Format Caller ID numbersStoring Caller ID entries in the directory Dialing a Caller ID number Deleting entries from the Caller list Deleting the displayed entryDeleting all entries Directory Store a number in the directoryReplacing a directory entry with a Caller ID entry Changing a stored numberMaking calls from the directory Reviewing and deleting directory contents Chain dialing from the directoryNumber for Memory Location Changing the Battery Battery replacement and handlingPower Failure Changing the Face PlatesRecycling NICKEL-METAL Hydride Batteries Light Signals Headset Jack and Belt ClipError LCD Screen MessagesCaller ID error message Sound SignalsTroubleshooting No displayYou experience static, noise, or fading in and out Dial tone is OK, but cannot dial outHandset does not ring Phone beepsMaintenance Causes of poor receptionRefresh battery Maximize Battery PerformanceKeep the contacts clean Charge it for a full 12 hoursTechnical Information Technical Information Sanyo Comfort Warranty What is not CoveredSOS Help Line Between 830 am 700 pm EST