Sanyo CLT-J30 instruction manual Battery setup, Telephone line connection, Tone/pulse setting

Page 6

GETTING STARTED

Battery setup

1. Remove the battery compartment cover on the handset, insert the battery, plug the cord into the jack (inside the compartment) and replace the cover.

2. Set the handset RINGER switch to ON, and place handset in the base.

3. Plug the AC adaptor into the Power DC 9V jack on the back of the base. Plug the other end into an electrical outlet. The CHARGE/IN USE indicator comes on verifying that the battery is charging. Charge the handset for 12 continuous hours prior to first use. The initial battery charge is important for best performance.

Note: It is normal for the handset and base to get warm when the handset is charging in the base.

1.Slide down the battery cover

3.Plug the wire into the jack

2.Place the batteries in the slot

4.Slide up the battery cover

Caution: Use only the Sanyo AC adaptor that is supplied with this phone. Using another AC adaptor may damage the phone.

Telephone line connection

4.Plug the telephone line cord into the TEL LINE jack on the back of the base. Plug the other end into a modular phone jack.

5.Wrap the cords through the brackets provided to ensure the base stands flat.

Tone/pulse setting

6.If you have Pulse (rotary) service, you will need to set the dial mode to pulse. If you have Touch-Tone service, do nothing as your phone has been set to Tone prior to shipment. If you do not know which type of service you have, contact your local telephone company.

7.To change to Pulse or Tone service, See Tone/pulse setting, page 10.

6

Image 6

Contents CLT-J30 Sanyo Canada IncTable of Contents Recycling NICKEL-METAL Hydride Batteries Introduction Main Features GHz TechnologyOther features Compander Plus Noise ReductionChecking package contents Getting StartedModular jack Battery setup Tone/pulse settingTelephone line connection Mounting on a wall Digital Security SystemNames and Controls HandsetBase Unit Initial Programming Language settingArea code setting Press FLASH/PROG until 1 ENG 2 FRA 3 ESP shows on screenDND setting LCD contrastResetting to default Idle animationBasics Volume adjustmentRinger switch Receiving a callRedialing Pre-dialing up to 32 digitsPress TALK/CALL Back Changing the pre-dial number Fast redialing Press TALK/CALL BackHandset locator Paging function Low battery warningVoice mail indicator Mute keyCaller ID Features Caller ID with Call WaitingCaller ID list Reviewing Caller ID list Format Caller ID numbersStoring Caller ID entries in the directory Dialing a Caller ID number Deleting entries from the Caller list Deleting the displayed entryDeleting all entries Directory Store a number in the directoryReplacing a directory entry with a Caller ID entry Changing a stored numberMaking calls from the directory Reviewing and deleting directory contents Chain dialing from the directoryNumber for Memory Location Changing the Battery Battery replacement and handlingPower Failure Changing the Face PlatesRecycling NICKEL-METAL Hydride Batteries Light Signals Headset Jack and Belt ClipError LCD Screen MessagesCaller ID error message Sound SignalsTroubleshooting No displayYou experience static, noise, or fading in and out Dial tone is OK, but cannot dial outHandset does not ring Phone beepsMaintenance Causes of poor receptionRefresh battery Maximize Battery PerformanceKeep the contacts clean Charge it for a full 12 hoursTechnical Information Technical Information Sanyo Comfort Warranty What is not CoveredSOS Help Line Between 830 am 700 pm EST