Sanyo CLT-J30 Sound Signals, Troubleshooting, No display, Caller ID error message, No dial tone

Page 27

SOUND SIGNALS

A long warbling tone	Signals an incoming call

Single Tone	A key is pressed

Three short beeps	Error tone

Two long beeps	Confirmation tone

One short beep and one long beep	Page signal

Two short beeps every 15 seconds	Low battery warning

TROUBLESHOOTING

CALLER ID

No display

•Is battery fully charged? Try replacing the battery.

•Make sure that the base is connected to a non-switched AC outlet. Disconnect the base from the plug and plug it in again.

•Did you order Caller ID service from your local telephone company? The display will not work unless you do this.

Caller ID error message

•The phone displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates either the presence of noise on the line, or that an invalid message has been sent from the telephone company.

TELEPHONE

No dial tone

•Check installation:

-Is the base power cord connected to a working outlet?

-Is the telephone line cord connected to the base unit and the wall jack?

•Disconnect the base from the wall jack and connect another phone to the same jack. If there is no dial tone in the second phone, the problem might be your wiring or local service.

•Is the handset out of range of the base?

•Make sure the battery is properly charged (12 continuous hours).

•Is the battery pack installed correctly?

•Did the handset beep when you pressed TALK/CALL BACK? Did the CHARGE/IN USE indicator come on? The battery may need to be charged.

27

Image 27

Contents Sanyo Canada Inc CLT-J30Table of Contents Recycling NICKEL-METAL Hydride Batteries Compander Plus Noise Reduction Main Features GHz TechnologyOther features IntroductionChecking package contents Getting StartedModular jack Battery setup Tone/pulse settingTelephone line connection Digital Security System Mounting on a wallHandset Names and ControlsBase Unit Press FLASH/PROG until 1 ENG 2 FRA 3 ESP shows on screen Language settingArea code setting Initial ProgrammingLCD contrast DND settingIdle animation Resetting to defaultReceiving a call Volume adjustmentRinger switch BasicsFast redialing Press TALK/CALL Back Pre-dialing up to 32 digitsPress TALK/CALL Back Changing the pre-dial number RedialingMute key Low battery warningVoice mail indicator Handset locator Paging functionCaller ID Features Caller ID with Call WaitingCaller ID list Reviewing Caller ID list Format Caller ID numbersStoring Caller ID entries in the directory Dialing a Caller ID number Deleting entries from the Caller list Deleting the displayed entryDeleting all entries Store a number in the directory DirectoryReplacing a directory entry with a Caller ID entry Changing a stored numberMaking calls from the directory Reviewing and deleting directory contents Chain dialing from the directoryNumber for Memory Location Battery replacement and handling Changing the BatteryPower Failure Changing the Face PlatesRecycling NICKEL-METAL Hydride Batteries Headset Jack and Belt Clip Light SignalsLCD Screen Messages ErrorNo display Sound SignalsTroubleshooting Caller ID error messagePhone beeps Dial tone is OK, but cannot dial outHandset does not ring You experience static, noise, or fading in and outCauses of poor reception MaintenanceCharge it for a full 12 hours Maximize Battery PerformanceKeep the contacts clean Refresh batteryTechnical Information Technical Information What is not Covered Sanyo Comfort WarrantyBetween 830 am 700 pm EST SOS Help Line