Getting started
Battery installation
Install the battery as shown below.
1Plug the battery connector securely into the socket.
3Slide the battery compartment cover towards the center of the handset until it clicks into place.
2Place the battery with the wires inside the battery compartment.
4Place the handset in the telephone base or charger to charge.
CHARGE light remains on when charging.
If the handset will not be used for a long period of time, disconnect and remove the battery to prevent any possible leakage.
Battery charging
Once you have installed the battery, the screen indicates the battery status. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging.
Battery indicators | Battery status | Action | |||||
The screen is blank, or | Battery has very little or no | Charge without interruption (at | |||||
displays Place in charger | charge. The handset cannot | least 30 minutes). | |||||
and |
|
| flashes. | be used. |
| ||
|
|
|
|
|
|
|
|
The screen displays Low | Battery has enough charge to | Charge without interruption | |||||
battery and |
| flashes. | be used for a short time. | (about 30 minutes). | |||
|
|
|
|
|
|
|
|
The screen displays | Battery is charged. | To keep the battery charged, | |||||
HANDSET X and |
| place it in the telephone base | |||||
|
|
| or charger when not in use. |
• If you are on a call in low battery mode, the handset beeps every 50 seconds.
• If you place the handset in the telephone base or charger without plugging in the battery, the screen displays No battery.