AT&T 900 MHz user manual Voice Help Menu, Audible Signals

Page 38

ANSWERING SYSTEM OPERATION

AT CORDLESS HANDSET OR TOUCH TONE PHONE

Voice Help Menu

Use the Voice Help Menu to access the answering system from your cordless handset or from a remote touch tone telephone, even if you do not know or remember the command codes.

1Connect with the answering system.

2Press 5. The system announces a list of operations and the buttons you need to press.

3At the end of the list, the system beeps twice to indicate it is ready to accept a command.

4You can access the Voice Help Menu any time after the system has given you the two-beep signal that it is ready to accept a command.

Audible Signals

Signal:	Means:

Long ring	Incoming call

Single beep	Valid button press

Three-part tone	Page

Repeating three-part tone	Handset Locator

Two short beeps	Handset is out of range

Four short beeps	Low battery

Four long beeps	Base is busy

Long buzzing tone	Error – unsuccessful action

Series of ascending tones	Action has been successful

“Chirp” after ring	Priority Call

37

Image 38

Contents USER’S Manual Advanced American Telephones. All rights reserved Contents About Caller ID with Call Waiting About Home and Local Area CodesInstallation Before You InstallTable/Desk and Wall Installation Install the handset batteryConnect the telephone line cord Softkeys Feature SetupMessage Window Display for Feature Setup Handset Ringer Off / Battery Save Telephone Feature SetupDial Mode Handset RingerCaller ID with Call Waiting Caller ID Feature SetupProgram Home and Local Area Codes Call List OptionsAnswering System Feature Setup Audible Message Alert Select Your AnnouncementRing Select / Toll Saver Change Priority Calling Code Change Remote Access CodePriority Call Signal Review Feature Settings Record Your Announcement from the BaseDelete an Announcement Set the ClockTalking Caller ID Feature Setup Caller Specific Outgoing Announcement Feature SetupAnnouncements Outgoing Local Review ADD Enter Number Done Menu Call ID DIR Directory MEM ANS SYS Delete Done Flash Handset VolumeMake Answer, or End a Call Preview aTemporary Tone Telephone OperationRedial MuteRecord a Phone Conversation HoldIntercom Changing Channels Headset JackSpeaker Base Ringer Volume AT the BasePage/Intercom Handset LocatorTelephone MEMORY/DIRECTORY Store a Number in MemoryReplace a Stored Number Store a Pause in a Memory NumberStore a Name with a Memory Number Store a Number and Name from Call History View Memory NumbersDelete Memory Numbers Edit Memory NumbersDial a Memory Number from the Base Priority Ring NumbersDial a Memory Number from the Handset Announcement Play/Silent Audible IndicatorsAbout Mailboxes Announcement Bypass Answering CallsCall Screening/Intercept Record a MemoListen To, Save & Delete Messages Function ButtonMessage Window Display CL ↔ AOFrom the Cordless Handset Call ScreeningConnect with the Answering System From a Touch Tone PhoneRemote Access Commands Function CommandEnd remote access call Audible Signals Voice Help MenuMemory Match Call WaitingIncoming Call History Review Call History Display DialDelete a Specific Call Record Caller ID OperationDelete Call Records from Call History Caller ID Display Messages Delete All Call RecordsOperating Range Batteries Battery LifeCharge the Handset Battery Pack Batteries Replace the Handset Battery Pack If you have no dial tone Case of DifficultyIf the phone does not work at all, check these items first To re-initialize the handset and baseIf the caller’s name or phone number is not displayed If you hear noise or interference when using the phoneIf the phone does not ring when you receive a call If you have difficulty hearing messages If speakerphone conversation sounds distortedIf messages are incomplete If CL appears in the Message Window If your outgoing announcement isn’t clearRemote Commands Answering SystemRemote Command Press