AT&T 900 MHz user manual Connect the telephone line cord

Page 7

INSTALLATION

Modular					Standard
telephone					electrical outlet
jack

3Connect the telephone line cord.

If you are wall mounting the phone, use the

short line cord and press the excess cord	4 Connect the
into the groove on the bottom of the base.	power cord.

5Mount the base on the wall. (WALL MOUNTING ONLY) Hold the base so the mounting knobs on the standard wall jack will fit into the holes on the bottom of the base. Slide the base down onto the knobs until it locks into place.

6Charge the handset battery.

Place the handset face up or face down in the base.

Charge the battery at least 12 hours the first time. After the first charge, the battery will quick-charge in only six hours.

7Check for dial tone.

After the batteries are charged, lift the handset and press P; you should hear a dial tone.

8Set up Telephone features. See page 8.

9Set up Caller ID features. See page 9.

10Set up Answering System features. See pages 10–14.

11Set up Caller Specific Outgoing Announcements and Talking Caller ID.

See pages 15–18.

6

Image 7

Contents USER’S Manual Advanced American Telephones. All rights reserved Contents About Home and Local Area Codes About Caller ID with Call WaitingBefore You Install InstallationInstall the handset battery Table/Desk and Wall InstallationConnect the telephone line cord Message Window Display for Feature Setup Feature SetupSoftkeys Handset Ringer Telephone Feature SetupDial Mode Handset Ringer Off / Battery SaveCall List Options Caller ID Feature SetupProgram Home and Local Area Codes Caller ID with Call WaitingAnswering System Feature Setup Ring Select / Toll Saver Select Your AnnouncementAudible Message Alert Priority Call Signal Change Remote Access CodeChange Priority Calling Code Record Your Announcement from the Base Review Feature SettingsSet the Clock Delete an AnnouncementCaller Specific Outgoing Announcement Feature Setup Talking Caller ID Feature SetupAnnouncements Outgoing Local Review ADD Enter Number Done Menu Call ID DIR Directory MEM ANS SYS Delete Done Preview a Handset VolumeMake Answer, or End a Call FlashMute Telephone OperationRedial Temporary ToneIntercom HoldRecord a Phone Conversation Headset Jack Changing ChannelsAT the Base Speaker Base Ringer VolumeHandset Locator Page/IntercomStore a Number in Memory Telephone MEMORY/DIRECTORYStore a Name with a Memory Number Store a Pause in a Memory NumberReplace a Stored Number View Memory Numbers Store a Number and Name from Call HistoryEdit Memory Numbers Delete Memory NumbersDial a Memory Number from the Handset Priority Ring NumbersDial a Memory Number from the Base About Mailboxes Audible IndicatorsAnnouncement Play/Silent Record a Memo Answering CallsCall Screening/Intercept Announcement BypassFunction Button Listen To, Save & Delete MessagesCL ↔ AO Message Window DisplayFrom a Touch Tone Phone Call ScreeningConnect with the Answering System From the Cordless HandsetFunction Command Remote Access CommandsEnd remote access call Voice Help Menu Audible SignalsIncoming Call History Call WaitingMemory Match Display Dial Review Call HistoryDelete Call Records from Call History Caller ID OperationDelete a Specific Call Record Delete All Call Records Caller ID Display MessagesOperating Range Charge the Handset Battery Pack Battery LifeBatteries Batteries Replace the Handset Battery Pack To re-initialize the handset and base Case of DifficultyIf the phone does not work at all, check these items first If you have no dial toneIf the phone does not ring when you receive a call If you hear noise or interference when using the phoneIf the caller’s name or phone number is not displayed If messages are incomplete If speakerphone conversation sounds distortedIf you have difficulty hearing messages If your outgoing announcement isn’t clear If CL appears in the Message WindowAnswering System Remote CommandsRemote Command Press