MicroNet Technology SP5054A/S, SP5052A/S user manual Quit, Debug, Parameters Usage

2.2 [quit]

Type quit will quit the Micronet SP5052A/S / SP5054A/S Gateway configuration mode. And turn back to login prompt.

---------------------------------------------------------------

usr/config$ quit Disconnecting...

login:

---------------------------------------------------------------

Note: It is recommended that type the “quit” command before you leave the console. If so, Micronet SP5052A/S / SP5054A/S Gateway will ask password again when next user connects to console port.

2.3 [debug]

Open debug message will show up specific information while Micronet SP5052A/S / SP5054A/S Gateway is in operation. After executing the debug command, it should execute command debug -open as well. One example is demonstrated below.

Debug message information and configuration

---------------------------------------------------------------

usr/config$ debug

Debug message information and configuration Usage:

debug [-add type1 [[type2]...]] -open -close -status

-status	Display the enabled debug flags.
-add	Add debug flag.
-delete	Remove specified debug flag.
-open	Start to show debug messages.
-close	Stop showing debug messages.
Example:
debug -add sip fsm

debug -add vp debug -open

---------------------------------------------------------------

Parameters Usage:

-status	Display the enabled debug flags.
-add	Add debug flag.

26