Line, Parameter Usages | MicroNet Technology SP5054A/S, SP5052A/S

2.13[line]

Configure the Hotline, Hunt and No Answer Forward

---------------------------------------------------------------

usr/config$ line

Gateway line information and configuration Usage:

line -config number [hunt number][hotline number]

line -print	Gateway line information.
hunt	Hunting group.
hotline	Hot line configuration.
fwdtype	forward type.
	To IP:
	0:disable
	1:un condition
	2:busy
forward	forward.
Example:
line -config 1 hunt 1 hotline 1003 forward1002
---------------------------------------------------------------
Parameter Usages:
-print	print out all current settings of line
-config	determine which line to configure
-hunt	set hunting group flag of each line.
	User can assign different hunt group number represent
	different hunt group. For example, if user assigns FXS TEL1
	as hunt group 1, and FXS TEL2 as hunt group 2, they will be
	determined as 2 different groups. On the other hand, if user
	assigns FXS TEL1 as hunt group 1, and FXS TEL2 as hunt
	group 1 too, when having incoming call to FXS TEL1, which is
	busy, this call will be route to FXS Line2. Note: FXO Lines
	and FXS TELs are treated as 2 different groups, so even they
	are in the same hunt group, call will only be routed to the
	same FXS or FXO Lines.
-hotline	set hotline table.
	The Hotline Mode is applied to the gateway will automatically
	dial out a phone number. In the other hand, user will hear ring
	back tone or dial tone immediately depended on
	configurations of destination device.
	34