MicroNet Technology SP5052A/S, SP5054A/S user manual

Page 24

Note:

Make sure the gateway serial cable is connected to correct COM port as the terminal selected, try the different port if failed.

yConfigure the COM Port Properties as following:

(1)Bits per second: 9600

(2)Flow control: None

Press ‘OK’ button, and start configuring Gateway.

yPower on the gateway, the message shows while booting. About 40 seconds for complete boot-up.

23

Image 24

Contents User’s Manual Model No. SP5052A/S, SP5054A/STable of Contents Page Web configuration Start to Configure Network InterfacePage SIP Config Page Security Config Line ConfigurationSystem Configuration Voice Setting For Advanced User Tone Setting Phone Book Page Prefix Configuration Page Routing Table FXO FXO Password IP Packet ToSPassword ROM Upgrade Flash CleanReboot System Commit DataCommand list Console AccessPage Telnet Help Quit DebugParameters Usage Reboot FlashCommit Usr/config$ ifaddr LAN information and configuration Usage IfaddrTime PingResponsed Sysconf No ResponsedParameter Usages Set as11 sip Security Parameters UsageLine Route Example Call out from FXO LineNONE0/GROUP1/ALL2 Prefix Pause Pbook Name, ip, or e164 Phonebook RulesVoice Display voice codec information and configuration Good condition, smaller sending packet size is Tone FxopwdRecord Page DSP Test Code Procedures of recording the disconnect tone According to the result, enter the Freq. into Tone table Page 【Example-2】 Page 22 tos 23 pt24 rom Selective RetransmissionMultiple Retransmission Attempts Passwd Auth Setmac