MicroNet Technology SP5054A/S, SP5052A/S user manual SIP Config

Page 7

z

z

z

z

connection.

PPPoE IP Address: In the PPPoE mode, this table will show the ip address that this unit gets from the ISP.

PPPoE Destination: In the PPPoE mode, this table will show the default gateway address that this unit gets from the ISP.

PPPoE DNS primary: In the PPPoE mode, this table will show the DNS ip address that this unit gets from the ISP.

After Remote Host Disconnection: This unit will reboot and re-connect to the ISP

1.2 SIP Config

This WEB page will help user to configure the information about the dial mode, GK information and some TCP/IP port for the communication. Please get more info about this configuration from the below detail descriptions. (See figure 3.5)

Parameter Description:

zMode – Pick up the calling mode for this gateway.

6

Image 7

Contents Model No. SP5052A/S, SP5054A/S User’s ManualTable of Contents Page Web configuration Network Interface Start to ConfigurePage SIP Config Page Line Configuration Security ConfigSystem Configuration Voice Setting For Advanced User Tone Setting Phone Book Page Prefix Configuration Page Routing Table FXO IP Packet ToS FXO PasswordPassword Flash Clean ROM UpgradeCommit Data Reboot SystemConsole Access Command listPage Telnet Help Debug QuitParameters Usage Flash RebootCommit Ifaddr Usr/config$ ifaddr LAN information and configuration UsagePing TimeResponsed No Responsed SysconfSet as Parameter Usages11 sip Parameters Usage SecurityLine Example Call out from FXO Line RouteNONE0/GROUP1/ALL2 Prefix Pause Pbook Phonebook Rules Name, ip, or e164Voice Display voice codec information and configuration Good condition, smaller sending packet size is Fxopwd ToneRecord Page DSP Test Code Procedures of recording the disconnect tone According to the result, enter the Freq. into Tone table Page 【Example-2】 Page 23 pt 22 tosSelective Retransmission 24 romMultiple Retransmission Attempts Passwd Setmac Auth