NEC N8103-89 manual Controller Configuration, Halt On Error setting procedure

93

2-6. Controller Configuration

If you press [4] on the Main Menu, the screen shown below appears.

This screen allows you to set the boot procedure at detection of an error and also see the system resources.

FastBuild (tm) Utility (c) xxxx-xxxx Promise Technology, Inc.

[ Adapter Configuration - Options ]

Halt On Error : Disable

[ System Resources Configuration ]

Installed Memory Address : DEDF8000 Size : 64M

Controller IRQ : 10

ATA IO Address : D800

XOR and HDMA IO Address : D400

Sequence Control IO Address : D000

Flash and SRAM Memory Address : DEE00000

[ Keys Available ]

[←,,Space] Change Option [ESC] Exit

„[Halt On Error]

Allows you to set the boot procedure at detection of an error during POST.

Halt On Error	Operation at start
Disable (recommended)	Disconnect the defected HDD and boot the system in the
	critical state.
Enable	Halt the boot process. To continue the boot process, press
	the [Esc] key manually.

Halt On Error setting procedure:

1.Press the [4] key on the Main Menu to activate [Controller Configuration]

2.Put the cursor on the setting value and press the [Space] key or the arrow key [←].

3.After changing the setting, press [Esc] to return to the Main Menu.

If you turn off the power of the server without returning to the Main Menu or press [Ctrl] + [Alt] + [Del] to reboot the server after changing the setting, the changing is cancelled.

Notice