![](/images/new-backgrounds/1190145/190145165x1.webp)
63
5-3. Installing the Disk Array Controller
1.Confirm the position of the PCI slot in which the disk array controller is installed and remove the corresponding additional slot cover.
Notice
Check
Save the removed additional slot cover carefully. The removed screw will be used to install the card. Do not lose them.
The card does not support the PCI
Some limitation may be imposed to the installation on the PCI slot depending on the type of the server. Before the installation, check the limitation following the User’s Guide of the server.
2.Insert the card into the PCI slot securely and fix it. To fix the card with screws, use the screw removed when the additional slot cover is removed.
This card (disk array controller)
Screw
3.To connect an additional battery to the card, install the battery in the same procedure.
When the card cannot be inserted into the PCI slot well, pull out it once and insert it again. Note that the cared may be damaged if excess force is given to it.
Notice | For details of how to install the additional battery, refer to the User’s |
| Guide of the |