NEC N8103-89 manual Connecting LED and Sata Cables, LED cable connection table

64

5-4. Connecting LED and SATA Cables

Connect the LED cable coming with the card to the HDD LED connector. For the connection, see the figure below and the connection table. For the connection to the motherboard, refer to the User’s Guide of the server. If it is hard to connect the LED cable, pull out the card from the PCI slot once and connect the cable to the card.

Next, connect a SATA cable to the SATA connector on the card. The channel number of the SATA cable should be the same as the channel number (port number) of the card.

LED cable

Port4

Port3

1 2 3 4

HDD LED connectors

Connect the black cable to this pin.

Connect the red cable to this pin. (This is not used for a single-line LED cable.)

SATA cables

LED cable connection table

		LED cable (coming with server)
		2-line cable	1-line cable
HDD LED	Pin 1	Connected with red cable	Not used
connector	Pin 2	Connected with black cable	Connected with black cable
	Pin 3	Not used	Not used
	Pin 4	Not used	Not used

„Depending on the type of the server, the LED cable has two lines or only a single line.

„For the connection of the LED cable to the motherboard, refer to the

Notice User’s Guide of the server.

„To use the N8154-09F SATA2 HDD Cage, connect the SATA cable coming with the cage to the card. For the detailed connection, refer to the User’s Guide of the additional HDD cage.