Motorola Programming Software and Repeater Setup for DR 3000

Chapter 4 Repeater Tuning and Programming

4.1Introduction

This chapter provides an overview of the MOTOTRBO Customer Programming Software (CPS), as well as the Tuner application, which are all designed for use on Windows 2000/XP operating system. These programs are available in one kit as listed in the Table 4-1. An Installation Guide is also included with the kit.

NOTE: Refer to the appropriate program on-line help files for the programming procedures.

Table 4-1. Repeater Software Program Kits

Description

Kit Number

MOTOTRBO CPS, Tuner and AirTracer Applications CD

GMVN5141_

4.2Customer Programming Software Setup

The Customer Programming Software setup, shown in Figure 4-1 is used to program the repeater.

NOTE: Refer to the appropriate program on-line help files for the programming procedures.

Repeater

ACC

Rear Accessory	Mobile & Repeater Rear
Connector	Programming Cable PMKN4010_

AC 120 / 240 VAC

Tx Port

Rx Port

USB

Figure 4-1. Customer Programming Software Setup from Rear Accessory Connector