8474 Studio 3500 UG Iss2 [2] 25/10/07 16:37 Page 15
BT Studio 3500 – Issue 1 – Edition 2.1
Using your phone | 15 | |
|
|
|
Switch the handset power on/off
1.To switch off, press and hold 
until the display goes off.
2.To switch the handset on, press and hold 
.
Make a call
1. Press 
. When you hear the dial tone, dial the phone number.
Preparatory dialling
1.Enter the phone number first. The number is shown in the display.
2.Press 
to dial the number.
End a call
1. Press 
, or place the handset back on the base/charger.
Receiving calls
1.When the phone rings, press 
to answer the call, or if the handset is on the base or charger, simply lift it to answer the call. If you would rather press 
after lifting the handset to receive a call, you will need to switch
Dialling numbers quickly
Numbers can also be dialled direct from the phonebook (page 20), the calls list (page 25), or the redial list (page 16).
If you make a mistake as you
enter the number, press 
to delete a digit.
Call timer
After the first 15 seconds of your call, the call timer is displayed.
At the end of your call, the total duration is not shown for 5 seconds.
Caller Display
If you have subscribed to your network’s Caller Display service, the caller’s number (or name, if an exact number match is found in the phonebook) will also be displayed, see page 24.
If you experience any problems, please call the Helpline on 0870 605 8047 or email bt.helpdesk@suncorptech.com