AT&T E5909B user manual Batteries will not hold a charge

Page 51

Appendix

Troubleshooting

My cordless handset beeps five times and is not perform- ing normally.

•Make sure the power cord is securely plugged into the base. Plug the unit into a different, working electrical outlet not controlled by a wall switch.

•Move the cordless handset closer to the telephone base. You might have moved out of range.

•Reset the telephone base. Unplug the unit’s electrical power. Wait for 15 seconds then plug it back in. Allow up to one minute for the cord- less handset and base to reset.

•Other electronic products can cause interference to your cordless phone. Try installing your telephone as far away from these types of electronic devices as possible: wireless routers, radios, radio towers, pager towers, cellular telephones, intercoms, room monitors, televi- sions, personal computers, kitchen appliances and other cordless telephones.

OTHER HANDSET ON (and then) OR OUT OF RANGE displays on my cordless hand- set.

•Place the cordless handset in base cradle for 1 minute to allow the cordless handset and base to resynchronize channels.

•Move the cordless handset closer to the telephone base. It might have moved out of range.

•If the cordless handset is in its base and the charging light does not come on, refer to the charge light is off in this troubleshooting guide.

•Reset the base. Unplug the unit’s electrical power. Wait for 15 seconds then plug it back in. Allow up to one minute for the cordless handset and base to reset.

•Other electronic products can cause interference with your cordless telephone. Try installing your telephone as far away from these types of electronic devices as possible: wireless routers, radios, radio towers, page towers, cellular telephones, intercoms, room monitors, televisions, personal computers, kitchen appliances and cordless telephones.

•Only one handset can be used to make or answer a call any- time. If another handset attempt to do so, the screen will display

OTHER HANDSET ON and then OR OUT OF RANGE. You might press PHONE/FLASH or SPEAKER again until no other hand- set is using the line.

The batteries will not hold a charge.

•Charge the battery in the cordless handset for at least 16 hours. For optimum daily performance, return the cordless handset to its base when not in use.

•Make sure the handset is placed in the charger correctly. The CHARGING light on the charger should be on.

•If the cordless handset is in the charger but the CHARGE light is not on, refer to “The CHARGING light is off” in this section.

•It may be necessary to purchase a new battery pack, please refer to the batteries section of this user’s manual.

•Your telephone might be malfunctioning. Please refer to the Warranty section of this user’s manual for further instruction.

•If the cordless handset is in its base and the charging light does not come on, refer to “The charge light is off” in this troubleshooting guide.

47

Page 50 Page 52
Image 51
Page 50 Page 52
Contents GHz Corded/Cordless Telephone/Answering System E5909B Need HELP? Information about Caller ID with Call Waiting See GHz Corded/Cordless Telephone/Answering System E5909B Table of contentsQuick reference guide Skip Press to skip message see Ringer Volume Set switch on sideBase Off, Low, High. see Menu Press to customize the telephone’s operation seeBelt clip Cordless Parts checklistTelephone line cords 1 long, 1 short Charger power Adapters Base handset Handset cord Telephone baseBefore you begin About Caller IdentificationTelephone operating range Telephone base installation Power adapterPlug the large Battery installation & charging Wall mounting Lock in placeSqueeze to open hinged wall mount Belt clip & optional headset Install belt clip as shown below if desiredChoose handset language Handset settingsSet handset date and time Set handset ringer tone Set handset ringer volumeChoose base language Base settingsChoose dial mode Choose base ringer volumeRing silencing Basic cordless handset operationMaking and answering calls Last number redialBasic base operation Handset locatorRedial Options while on calls Temporary tone dialing Way conference callsPhone Hold INT Intercom Call transfer Call transferINT Press INT/DELETE to page base Intercom callsIntercom calls Handling incoming callsPHONE/FLASH Intercom calls Directories handset and base DirectoriesSee Steps 4-7 on pages To create a Speed Dial entryDirectory dialing To create a directory entryTo call a Speed Dial number To edit or delete a Speed Dial numberEntering names into directories To enter a nameOptions while entering names To assign a distinctive ring cordless handset only Entering phone number and assigning distinctive ringTo enter a number Options while entering numbersTo call a displayed number Directory searchTo browse through the directory To search alphabeticallyTo delete an entry To copy, edit or delete an entryTo make an entry a Speed Dial entry cordless handset only To edit an entryCaller ID and Call Waiting Functions How Caller ID worksTo determine the callers name Contrast Adjustment base onlyOn-Screen Message Reason Not revealed at callers requestCID memory Memory CapacityReviewing the CID Memory Storing a record from the CID Memory into the directory Dialing from CID MemoryDeleting a number from the CID Memory Deleting all CID records BaseCordless handset Call waiting Press again to quit see Press to review or set clock see Message capacityPress Clock Day and time announcementsTo set day and time To check day and timeTo play your outgoing announcement To record your outgoing announcementTo delete your outgoing announcement Feature options Changing feature optionsTo delete all messages Message playbackAnnouncements Options during playbackBeep Recording and playing memosTo record a memo To play back a memoMessage counter displays Remote access Screen display messages Display screen messages, lights and tonesAlert tones Indicator lightsMy telephone does not work at all TroubleshootingBatteries will not hold a charge Hear noise My cordless handset does not ring when I receive a call My Caller ID is CL flashes Important safety instructions Especially About Cordless Telephones Especially About Telephones Answering Systems Precautions for Users of Implanted Cardiac PacemakersFCC part 68 and Acta FCC part Limited warranty Limited warranty Please retain your receipt as your proof of purchase Index Technical specifications Remote access wallet card Cut along dotted lineFold card here
Top Page Image Contents