Modifying Existing Phones | NetVanta 7100 Administrator’s Guide |
|
|
4.In the Change Phone MAC Address/Model menu (see Figure 26), enter the New MAC Address (or choose one from the Known Address
Figure 26. Change Phone MAC Address/Model Menu
5.Confirm that the phone model is correct.
6.Select Apply to apply changes and return to the Edit User menu.
7.Scroll to the bottom of the Edit User menu and select Apply.
8.Select OK to accept the prompt and reboot the new phone so it will download the configuration from the NetVanta 7100. (If the phone will be rebooted at a later time, refer to the steps provided in Rebooting a Phone on page 40.)
Rebooting a Phone
Periodically, a phone may require rebooting to accept a new configuration or software update. There are two ways to reboot a phone:
1.Simultaneously press and hold the correct keys (key combinations are shown in Table 5) for 3 seconds or more until a confirmation tone is heard.
2.Press the Menu key and select Settings, Advanced, Restart Phone (the user password is required to access this menu).
The reboot process may take a few minutes. The phone will cycle through multiple information screens on the display until it completes by returning to the idle display. In the case of problems, it may be possible to restore normal phone operation without rebooting. Contact your system administrator before attempting to reboot the phone.
Table 5. Reboot Phone Key Combinations
ADTRAN/Polycom IP Phone Model | Key Combinations |
|
|
|
|
SoundPoint IP 300 and 301 | |
|
|
SoundPoint IP 500 and 501 | |
|
|
SoundPoint IP 600 and 601 | |
|
|
SoundStation® IP 4000 | *, #, Volume+, Select |
|
|
40 | Copyright © 2007 ADTRAN, Inc. |