Viewing Records
If you push 
, the screen will jump to the right so you can view the rest of the characters on the right side screen. Once on that screen, you will see a 
to jump back to the left screen.
Scrolling through records
Push 
or 
to go from one record to the next. You can scroll one record at a
time, or you can scroll quickly by pushing and holding 
or 
without releasing (after a slight delay the records will start to scroll quickly). Logio scrolls circularly, so you can go from the top of the sorting order (alphabet) directly to the bottom by
pushing 
, and you can go from the bottom of the sorting order directly to the top
by pushing 
.
Jumping to top and bottom records
If you are viewing a record that is not the first (top) record or last (bottom) record,
you can push and hold 
and push 
to go to the first record, or push and hold
and push 
to go to the last record.
Searching for specific records
You can search for (jump to) records beginning with specific characters by pushing alphanumeric buttons in “view” mode. Push the first character (or characters, up to a maximum of eight) of the website name or address (or whatever you store on line 1 of the record) and a prompt will come onto the screen that says “Go to:” and shows
the character(s) you have entered. Wait several seconds or push 
and the screen will jump to the first record that starts with that/those letter(s), number(s), or special character(s). If there is no record starting with the character(s) you have specified, Logio will go to the first record that alphabetically follows that record, unless there is no following record, in which case it will go to the first record that precedes the search character(s) you have specified. Note that when entering search characters,
the 
button does not work because search terms are not case sensitive.
Logio User’s Manual, page 20