Panasonic KX-TG8301NZ Making/answering calls, intercom Problem Cause/solution

Page 42

Useful Information

Making/answering calls, intercom

Problem	Cause/solution
w is flashing.	L The handset is not registered to the base unit.
	Register it (page 29).
	L The handset is too far from the base unit.
	Move closer.
	L The base unit’s AC adaptor is not connected.
	Check the connections.
	L You are using the handset or base unit in an
	area with high electrical interference. Place
	the base unit and use the handset away from
	sources of interference.
Noise is heard, sound cuts in	L You are using the handset or base unit in an
and out.	area with high electrical interference. Place
	the base unit and use the handset away from
	sources of interference.
	L Move closer to the base unit.
	L If you use a DSL/ADSL (JetStream) service,
	we recommend that you contact your
	DSL/ADSL service provider to have a
	DSL/ADSL Splitter installed. We do not
	recommend the use of generic DSL/ADSL
	filters. Contact your DSL/ADSL service
	provider for details.
The handset does not ring.	L The ringer volume is turned off. Adjust ringer
	volume (page 22).
	L Night mode is turned on. Turn it off
	(page 26).
I cannot make a call.	L The handset is too far from the base unit.
	Move closer and try again.
	L Another unit is in use. Wait and try again later.
	L If you are using a BT double adaptor to
	connect the unit, remove the adaptor and
	connect the unit to the phone wall socket
	directly. If the unit operates properly, check or
	replace the adaptor.
	L You dialled a call restricted number (page 27).
	L The key lock feature is turned on. Turn it off
	(page 18).
	L The unit is not designed to be used with
	rotary/pulse dialling services.

42

Image 42

Contents Model No. KX-TG8301NZ Introduction Caller ID ServiceVoice Mail Service PreparationAdditional/replacement accessories Accessory informationSupplied accessories Product informationExpanding your phone system For your safety Battery General noticesRechargeable Ni-MH batteries AAA R03 size Important notice Important safety instructionsFor best performance Base unit location/avoiding noiseIntroduction Handset ControlsBase unit Charge contacts B x LocatorDisplay Using the joystickTo adjust the receiver or speaker Soft keysConnections Battery installation and replacement During a power failureIf you subscribe to a DSL/ADSL service Battery charge Battery level Battery iconSetting up the unit before use Screen saver modeTurning the power on/off Display languageHeadset optional Time Settings Set Date & TimeBelt clip Date and timeMaking calls Mute Useful features during a callAnswering calls Recall/flashCall share Key lockHandset voice enhancer Call privacyCategories Handset phonebookAdding entries Finding and calling a phonebook entryOne touch dial Editing entriesErasing entries One Touch DialCopying an entry Copying phonebook entriesChain dial Copying all entriesOn/Off Ring Delay 60 sec Select Category Programmable settingsRingtone*2, *3 Night Mode Start/End Programming by scrolling through the display menusProgramming Programming Time adjustment Caller ID subscribers only Special instructions for programmable settingsMemo alarm OnceNight mode Time AdjustmentRinger Setup iM Setting call restriction Selecting area codes to be deleted automaticallyChanging the base unit PIN Personal Identification Number Operating additional units Registering a unitIncoming call barring Caller ID subscribers only Add Bar List iMRegistering a handset to a base unit DeregistrationCancelling a base unit Setting the repeater modeIncreasing the range of the base unit Using toll services from Telecom or another company Using Caller ID serviceCaller ID features Missed callsViewing the caller list and calling back Category settings for phonebookCaller list Editing a caller’s phone number before calling backEdit and Call Erasing caller informationStoring caller information to the phonebook Add PhonebookVoice mail service Intercom Making an intercom callAnswering an intercom call Base unit Press Handset locatorAnswering a transferred call Press C to answer Base unit Press Handset Press ihCharacter entry Characters available in each character entry modeWhen the unit displays the character entry screen Character entry modesExtended 1 character table N Extended 2 character table OCyrillic character table P Error messages Troubleshooting General use Problem Cause/solutionProblem Cause/solution Programmable settings Problem Cause/solutionBattery recharge Problem Cause/solution Making/answering calls, intercom Problem Cause/solution Caller ID Problem Cause/solution Liquid damage Problem Cause/solution Specifications Index Page Customer Support Centre Tel. No Sales Department PNQX1195ZA CC0608DC0For your future reference Copyright