Panasonic KX-TG8301NZ operating instructions Programmable settings Problem Cause/solution

Page 41

	Useful Information

Problem	Cause/solution
I do not know how to erase y	L There are unviewed missed calls remaining.
(Missed call) from the display.	View them using the following method.
	1 K (centre of joystick) i j i M
	2 Push the joystick down to search from the
	most recent call, or push the joystick up to
	search from the oldest call.

Programmable settings

Problem	Cause/solution
I have changed the display	L Change the display language (page 14).
language to a language I
cannot read.
While programming, the	L A call is being received. Answer the call and
handset starts to ring.	start again after hanging up.
While programming, the	L A call matching an entry in the bar call list is
display returns to standby	being received. Wait and try again later.
mode.
I cannot register a handset to a	L The maximum number of base units (4) is
base unit.	already registered to the handset. Cancel
	unused base unit registrations from the
	handset (page 30).
	L The maximum number of handsets (6) is
	already registered to the base unit. Cancel
	unused handset registrations from the base
	unit (page 29).
	L You entered the wrong PIN. If you forget your
	PIN, contact your nearest Panasonic service
	centre.
	L Place the handset and the base unit away
	from other electrical appliances.

Battery recharge

Problem	Cause/solution
The handset beeps and/or )	L Battery charge is low. Fully charge the
flashes.	batteries (page 13).
I fully charged the batteries, but	L Clean the charge contacts and charge again
) still flashes.	(page 13).
	L It is time to replace the batteries (page 12).
I fully charged the batteries, but	L Clean the battery ends (S, T) and the
the operating time seems to be	charge contacts with a dry cloth, and charge
shorter.	again.

41

Image 41

Contents Model No. KX-TG8301NZ Voice Mail Service Caller ID ServiceIntroduction PreparationSupplied accessories Accessory informationAdditional/replacement accessories Product informationExpanding your phone system For your safety Rechargeable Ni-MH batteries AAA R03 size BatteryGeneral notices For best performance Important safety instructionsImportant notice Base unit location/avoiding noiseIntroduction Base unit ControlsHandset Charge contacts B x LocatorTo adjust the receiver or speaker Using the joystickDisplay Soft keysConnections If you subscribe to a DSL/ADSL service Battery installation and replacementDuring a power failure Battery level Battery icon Battery chargeTurning the power on/off Screen saver modeSetting up the unit before use Display languageBelt clip Time Settings Set Date & TimeHeadset optional Date and timeMaking calls Answering calls Useful features during a callMute Recall/flashHandset voice enhancer Key lockCall share Call privacyAdding entries Handset phonebookCategories Finding and calling a phonebook entryErasing entries Editing entriesOne touch dial One Touch DialChain dial Copying phonebook entriesCopying an entry Copying all entriesRingtone*2, *3 Night Mode Start/End Programmable settingsOn/Off Ring Delay 60 sec Select Category Programming by scrolling through the display menusProgramming Programming Memo alarm Special instructions for programmable settingsTime adjustment Caller ID subscribers only OnceRinger Setup iM Night modeTime Adjustment Changing the base unit PIN Personal Identification Number Setting call restrictionSelecting area codes to be deleted automatically Incoming call barring Caller ID subscribers only Registering a unitOperating additional units Add Bar List iMDeregistration Registering a handset to a base unitIncreasing the range of the base unit Cancelling a base unitSetting the repeater mode Caller ID features Using Caller ID serviceUsing toll services from Telecom or another company Missed callsCaller list Category settings for phonebookViewing the caller list and calling back Editing a caller’s phone number before calling backStoring caller information to the phonebook Erasing caller informationEdit and Call Add PhonebookVoice mail service Answering an intercom call IntercomMaking an intercom call Answering a transferred call Press C to answer Handset locatorBase unit Press Base unit Press Handset Press ihWhen the unit displays the character entry screen Characters available in each character entry modeCharacter entry Character entry modesCyrillic character table P Extended 1 character table NExtended 2 character table O Error messages General use Problem Cause/solution TroubleshootingBattery recharge Problem Cause/solution Problem Cause/solutionProgrammable settings Problem Cause/solution Making/answering calls, intercom Problem Cause/solution Caller ID Problem Cause/solution Liquid damage Problem Cause/solution Specifications Index Page For your future reference PNQX1195ZA CC0608DC0Customer Support Centre Tel. No Sales Department Copyright