Panasonic KX-TG8301NZ operating instructions Liquid damage Problem Cause/solution

Page 44

Useful Information

Liquid damage

Problem	Cause/solution
Liquid or other form of moisture	L Disconnect the AC adaptor and telephone line
has entered the handset/base	cord from the base unit. Remove the batteries
unit.	from the handset and leave to dry for at least
	3 days. After the handset/base unit are
	completely dry, reconnect the AC adaptor and
	telephone line cord. Insert the batteries and
	charge fully before use. If the unit does not
	work properly, contact your nearest
	Panasonic service centre.

Caution:

LTo avoid permanent damage, do not use a microwave oven to speed up the drying process.

Image 44

Contents Model No. KX-TG8301NZ Caller ID Service Voice Mail ServiceIntroduction PreparationAccessory information Supplied accessoriesAdditional/replacement accessories Product informationExpanding your phone system For your safety Rechargeable Ni-MH batteries AAA R03 size BatteryGeneral notices Important safety instructions For best performanceImportant notice Base unit location/avoiding noiseIntroduction Controls Base unitHandset Charge contacts B x LocatorUsing the joystick To adjust the receiver or speakerDisplay Soft keysConnections If you subscribe to a DSL/ADSL service Battery installation and replacementDuring a power failure Battery charge Battery level Battery iconScreen saver mode Turning the power on/offSetting up the unit before use Display languageTime Settings Set Date & Time Belt clipHeadset optional Date and timeMaking calls Useful features during a call Answering callsMute Recall/flashKey lock Handset voice enhancerCall share Call privacyHandset phonebook Adding entriesCategories Finding and calling a phonebook entryEditing entries Erasing entriesOne touch dial One Touch DialCopying phonebook entries Chain dialCopying an entry Copying all entriesProgrammable settings Ringtone*2, *3 Night Mode Start/EndOn/Off Ring Delay 60 sec Select Category Programming by scrolling through the display menusProgramming Programming Special instructions for programmable settings Memo alarmTime adjustment Caller ID subscribers only OnceRinger Setup iM Night modeTime Adjustment Changing the base unit PIN Personal Identification Number Setting call restrictionSelecting area codes to be deleted automatically Registering a unit Incoming call barring Caller ID subscribers onlyOperating additional units Add Bar List iMRegistering a handset to a base unit DeregistrationIncreasing the range of the base unit Cancelling a base unitSetting the repeater mode Using Caller ID service Caller ID featuresUsing toll services from Telecom or another company Missed callsCategory settings for phonebook Caller listViewing the caller list and calling back Editing a caller’s phone number before calling backErasing caller information Storing caller information to the phonebookEdit and Call Add PhonebookVoice mail service Answering an intercom call IntercomMaking an intercom call Handset locator Answering a transferred call Press C to answerBase unit Press Base unit Press Handset Press ihCharacters available in each character entry mode When the unit displays the character entry screenCharacter entry Character entry modesCyrillic character table P Extended 1 character table NExtended 2 character table O Error messages Troubleshooting General use Problem Cause/solutionBattery recharge Problem Cause/solution Problem Cause/solutionProgrammable settings Problem Cause/solution Making/answering calls, intercom Problem Cause/solution Caller ID Problem Cause/solution Liquid damage Problem Cause/solution Specifications Index Page PNQX1195ZA CC0608DC0 For your future referenceCustomer Support Centre Tel. No Sales Department Copyright