Panasonic VA-12021, VA-824, VA-30940D, VA-30920, VA-1232 To store a number from extension 10 only

Page 11

With system speed dial you use a two digit address number instead of dialing the whole telephone number.

You can use the address number for system speed dial on all system telephones. Up to 90 address numbers for system speed dial from 00 to 89 can be stored, and a telephone number can be stored even while the other telephones are being used. Telephone numbers of up to 16 digits including *, #, FLASH and PAUSE can be stored. If a new telephone number is stored, the old telephone number is erased and new contents are set.

To store a number (from extension 10 only)

1.Press ON/OFF key

*Listen for the intercom dial tone from speaker.

+

HOLD

KJ

The ON/OFF indicator will light up.

2.Press AUTO key

3.Press any address number from 00 to 89

4.Press the telephone number for speed dial storing

.

5.Press HOLD key

(If you wish to store another system speed dial, repeat steps 2 to 5 for each case)

6.Press ON/OFF key

*The ON/OFF indicator goes off.

.

;:

10

Image 11
Contents E r a t i n g Instructions COL Table of Contents Toll Restriction Pause Function Flash Function Signal Conversion from pulseCase of a Power Failure Intercom Dial Tone Mute SpeakerphonePage 18-f @iI Press any available line key To store a number To save a numberTo make a call To erase a number stored To make a call \ITo store a number from extension 10 only To erase a stored number from extension 10 only To make a callPickinq up held line To answer a call on a telephone which ringsTo answer a call on a telephone which does not ring Putting call on holdIf the extension is busy Transferrinq a call to another extensionAlternatively Three-party conference Line indicator will flash greenPage BEI If MIC key is not pressesdTo release hold Putting an intercom call on holdConf For VA-824 LJON/OR Features are stored as followsWhen using FF key To release SettinqPress ON/OFF key Storing To erase stored number One-touch operationIEI EaON/OR When dialinq Call is transmitted by tone signals Answering CallingSetting time from extension 10 only To release alarm setting Settinq alarmConfirminq number Dial number displayDisplay during call Other cases Optional Equipment To answer telephone which does not ringTo release door lock To silence an alarm on telephoneTo silence an alarm on sensor To enter an account number and dial To call an extension while talking with another extension To transfer an outside call to an extensionYou will bear the intercom dial tone from handset Dimensions Inch Heigh x Width x Depth, Weight Pound Page Receiving and Following Th?@i% ‘cr ‘-‘ Storing and Setting Press El one-touch key Ress Conf