Panasonic VA-30910, VA-824, VA-30940D, VA-30920, VA-1232 To transfer an outside call to an extension

Page 38

On the DSS there is a key for each extension to enable direct contact.

In addition, the status of each extension is shown with a lamp indicator.

(VA-1232:Maximum of 4 units.)

To transfer an outside call to an extension -

 

Answer the call

 

 

2 . Press the station key for the transferee

 

 

 

* The outside call is automatically put on hold.

 

F!l

 

 

 

C O N

3 .

Press CONF key when answered

 

 

 

 

4 . Hang up

 

To call an extension while talking with another extension

 

\I!

Press the desired station key while talking with another

_

extension or while calling

 

 

ha

 

* The call will be automatically ended and the desired

 

 

 

extension will be called.

 

A station indicator will light up when

 

 

An extension is busy

 

 

An

extension is called

 

Do-not-disturb is set

A station indicator will flash when

An extension is called with an intercom telephone

rs m

f

Z O N E

hEI

+

1.Lift handset

2.Press ZONE key for zone number to be paged

3.Speak into the mouthpiece of handset to make announcement

37

Image 38
Contents E r a t i n g Instructions COL Table of Contents Intercom Dial Tone Mute Speakerphone Pause Function Flash Function Signal Conversion from pulseCase of a Power Failure Toll RestrictionPage 18-f @iI Press any available line key To store a number To save a numberTo make a call To make a call \I To erase a number storedTo store a number from extension 10 only To make a call To erase a stored number from extension 10 onlyPutting call on hold To answer a call on a telephone which ringsTo answer a call on a telephone which does not ring Pickinq up held lineIf the extension is busy Transferrinq a call to another extensionAlternatively Line indicator will flash green Three-party conferencePage If MIC key is not pressesd BEIPutting an intercom call on hold To release holdConf For VA-824 Features are stored as follows LJON/ORWhen using FF key Settinq To releasePress ON/OFF key Storing One-touch operation To erase stored numberIEI EaON/OR When dialinq Call is transmitted by tone signals Calling AnsweringSetting time from extension 10 only Settinq alarm To release alarm settingConfirminq number Dial number displayDisplay during call Other cases To answer telephone which does not ring Optional EquipmentTo release door lock To silence an alarm on telephoneTo silence an alarm on sensor To enter an account number and dial To transfer an outside call to an extension To call an extension while talking with another extensionYou will bear the intercom dial tone from handset Dimensions Inch Heigh x Width x Depth, Weight Pound Page Receiving and Following Th?@i% ‘cr ‘-‘ Storing and Setting Press El one-touch key Ress Conf