Panasonic VA-30941D, VA-824, VA-30940D, VA-30920, VA-30910, VA-30942D, VA-30960, VA-30965, VA-82110 manual

Page 5

.. ;

- .

.’

_’

(VA-12022 key telephone with display)

1 Ringer volume control

For adjusting incoming ringing tone. 2 Speaker volume control

For adjusting voice level of intercom voice call and speakerphone receiving voice level. 3 Speaker

For listening to ringing tone and voice.

4H a n d s e t

5 Display

Indicates the time and the number dialed. (VA-12022, 12022-B only) 6 REDIAL k e y

Used to redial the last number dialed. Also, use to insert a pause between the digits of a telephone number storing for automatic dialing.

7 H O L D

Puts an outside or intercom call on hold. 8 C O N F k e y

For conference with three-party and setting privacy release. 9 FLASH key

Pressing this key performs the same function as replacing the handset and lifting it up again.

10 ON/OFF key _

Used to place a call without lifting the handset or to store a number for speed dialing. 11 ON/OFF indicator

Stays ON while ON/OFF key is pressed down.

12 Dialing keys

13 Microphone

Enables telephone conversations with the handset on-hook and hands-free speach.

14 Telephone number list

A list for people whose numbeys are stored in the respective memory for your

convenience.

-

 

4

Image 5
Contents E r a t i n g Instructions COL Table of Contents Case of a Power Failure Pause Function Flash Function Signal Conversion from pulseIntercom Dial Tone Mute Speakerphone Toll RestrictionPage 18-f @iI Press any available line key To store a number To save a numberTo make a call To erase a number stored To make a call \ITo store a number from extension 10 only To erase a stored number from extension 10 only To make a callTo answer a call on a telephone which does not ring To answer a call on a telephone which ringsPutting call on hold Pickinq up held lineIf the extension is busy Transferrinq a call to another extensionAlternatively Three-party conference Line indicator will flash greenPage BEI If MIC key is not pressesdTo release hold Putting an intercom call on holdConf For VA-824 LJON/OR Features are stored as followsWhen using FF key To release SettinqPress ON/OFF key Storing To erase stored number One-touch operationIEI EaON/OR When dialinq Call is transmitted by tone signals Answering CallingSetting time from extension 10 only To release alarm setting Settinq alarmConfirminq number Dial number displayDisplay during call Other cases Optional Equipment To answer telephone which does not ringTo release door lock To silence an alarm on telephoneTo silence an alarm on sensor To enter an account number and dial To call an extension while talking with another extension To transfer an outside call to an extensionYou will bear the intercom dial tone from handset Dimensions Inch Heigh x Width x Depth, Weight Pound Page Receiving and Following Th?@i% ‘cr ‘-‘ Storing and Setting Press El one-touch key Ress Conf