Panasonic VA-82110, VA-824, VA-30940D manual To save a number, To make a call, To store a number

Page 9

You can temporarily save a telephone number at any time so that it can easily be dialed again later.

A number of up to 16 digits can be saved.

To save a number

AUTO

IEI

+

SAVE

IEI

1.Press AUTO key while speaking

2.Press SAVE key

*The telephone number of the party you are speaking to will be saved.

To make a call

1.Press any available line key

*Listen for the outside dial tone. The line indicator will light up green.

2.Press SAVE key

*The saved telephone number will be dialed automatically.

3.Lift handset and speak when answered

You can store up to 10 telephone numbers for speed dialing on your own telephone. This is particularly convenient for storing long numbers which you call frequently.

You can store up to 16 digits including *, #, FLASH and PAUSE.

By entering AUTO plus system speed address number instead of the telephone number, you can store the system speed address number on the one-touch speed dial function.

If a new number is stored, the old number is erased and the new contents are set.

To store a number

1.Press ON/OFF key

*Listen for the intercom dial tone from speaker. The ON/OFF indicator will light up.

2.Press AUTO key

3.Press One-touch key you wish to store

4.Press the telephone number .for one touch speed dial storing

-

8

Image 9

Contents E r a t i n g Instructions COL Table of Contents Case of a Power Failure Pause Function Flash Function Signal Conversion from pulseIntercom Dial Tone Mute Speakerphone Toll RestrictionPage 18-f @iI Press any available line key To save a number To make a callTo store a number To erase a number stored To make a call \ITo store a number from extension 10 only To erase a stored number from extension 10 only To make a callTo answer a call on a telephone which does not ring To answer a call on a telephone which ringsPutting call on hold Pickinq up held lineTransferrinq a call to another extension AlternativelyIf the extension is busy Three-party conference Line indicator will flash greenPage BEI If MIC key is not pressesdTo release hold Putting an intercom call on holdConf For VA-824 LJON/OR Features are stored as followsWhen using FF key To release SettinqPress ON/OFF key Storing To erase stored number One-touch operationIEI EaON/OR When dialinq Call is transmitted by tone signals Answering CallingSetting time from extension 10 only To release alarm setting Settinq alarmDial number display Display during callConfirminq number Other cases Optional Equipment To answer telephone which does not ringTo silence an alarm on telephone To silence an alarm on sensorTo release door lock To enter an account number and dial To call an extension while talking with another extension To transfer an outside call to an extensionYou will bear the intercom dial tone from handset Dimensions Inch Heigh x Width x Depth, Weight Pound Page Receiving and Following Th?@i% ‘cr ‘-‘ Storing and Setting Press El one-touch key Ress Conf