Panasonic VA-824, VA-30940D, VA-30920, VA-30910, VA-30941D, VA-30942D, VA-30960, VA-1232 Other cases

Page 34

Other cases

1. Press ON/OFF key

2. Press REDIAL key

3. Press desired function key or number

* The’stored number will appear on the display.

One-touch speed dial:

One-touch key

 

Flexible feature number : FF key

 

Save

dial number:

SAVE key

 

Redial

number:

REDIAL key

 

Call forward

number:

#3

 

Alarm

setting

time:

#4

 

Your

extension number:

1

 

Outside line

number:

Line key

 

4.Press ON/OFF key

*The time appears on the display.

A short tone sounds from the speaker every three minutes when you are making outside calls. In this way you can keep a check on how long you have been talking.

A warning can be set to sound from the telephone after a certain time has elapsed when a call has been put on hold (immediately, 30 seconds, 1 minute or 2 minutes after placing on hold). The tone will remind you that the call is on hold should you have forgotten about it. The warning tone only sounds during hold if the telephone is on-hooked.

 

 

Each telephone can be ranked so that its use may be restricted, for example, to local calls

 

 

or long distance calls. The ranking is of four types: intercom calls only, local calls only,

 

 

local calls and 41 1, 976 and 555 calls, and no restriction. Before using your telephone, as

 

 

certain which type it is. -

.-:.

 

Telephones which are to local calls only or local calls and 41 l,-976 and 555 calls can also

;;;

be programmed for the system speed dialing.

3 3

Image 34
Contents E r a t i n g Instructions COL Table of Contents Intercom Dial Tone Mute Speakerphone Pause Function Flash Function Signal Conversion from pulseCase of a Power Failure Toll RestrictionPage 18-f @iI Press any available line key To make a call To save a numberTo store a number To make a call \I To erase a number storedTo store a number from extension 10 only To make a call To erase a stored number from extension 10 onlyPutting call on hold To answer a call on a telephone which ringsTo answer a call on a telephone which does not ring Pickinq up held lineAlternatively Transferrinq a call to another extensionIf the extension is busy Line indicator will flash green Three-party conferencePage If MIC key is not pressesd BEIPutting an intercom call on hold To release holdConf For VA-824 Features are stored as follows LJON/ORWhen using FF key Settinq To releasePress ON/OFF key Storing One-touch operation To erase stored numberIEI EaON/OR When dialinq Call is transmitted by tone signals Calling AnsweringSetting time from extension 10 only Settinq alarm To release alarm settingDisplay during call Dial number displayConfirminq number Other cases To answer telephone which does not ring Optional EquipmentTo silence an alarm on sensor To silence an alarm on telephoneTo release door lock To enter an account number and dial To transfer an outside call to an extension To call an extension while talking with another extensionYou will bear the intercom dial tone from handset Dimensions Inch Heigh x Width x Depth, Weight Pound Page Receiving and Following Th?@i% ‘cr ‘-‘ Storing and Setting Press El one-touch key Ress Conf