Panasonic VA-20861, VA-824, VA-30940D, VA-30920, VA-30910, VA-30941D, VA-30942D, VA-30960 manual Iei

Page 27

Using the REDIAL key a pause can be inserted in the dialing sequence.

The pause time can be system programmed to 2 or 3 seconds. For example, a pause can be inserted between, MCI or Sprint access number 123-4567 and telephone number 201-392- 4382 and stored for speed dialing or on a one-touch key as follows.

Access No.

Pause

Phone No.

 

 

 

 

 

One-touch key 1

 

 

One-touch key 2

Storinq

1.Press ON/OFF key

*Listen for the intercom dial tone. ON/OFF indicator will light up.

2.Press AUTO key

3.Press any numbers within the range 00 to 89 for system speed dialing or One-touch key (e.g. one-touch key 1)

4.Press the access number 1234567 for storing

5.Press REDIAL key twice to store two pauses

6.Press HOLD key

IEI-

 

AUTO

7. Press AUTO key to store the telephone number

 

a.Press the address number for system speed dialing or One-touch key (e.g. one-touch key 2)

:i:

. .

.-

.

. ..,

26

Image 27
Contents E r a t i n g Instructions COL Table of Contents Toll Restriction Pause Function Flash Function Signal Conversion from pulseCase of a Power Failure Intercom Dial Tone Mute SpeakerphonePage 18-f @iI Press any available line key To save a number To make a callTo store a number To erase a number stored To make a call \ITo store a number from extension 10 only To erase a stored number from extension 10 only To make a callPickinq up held line To answer a call on a telephone which ringsTo answer a call on a telephone which does not ring Putting call on holdTransferrinq a call to another extension AlternativelyIf the extension is busy Three-party conference Line indicator will flash greenPage BEI If MIC key is not pressesdTo release hold Putting an intercom call on holdConf For VA-824 LJON/OR Features are stored as followsWhen using FF key To release SettinqPress ON/OFF key Storing To erase stored number One-touch operationIEI EaON/OR When dialinq Call is transmitted by tone signals Answering CallingSetting time from extension 10 only To release alarm setting Settinq alarmDial number display Display during callConfirminq number Other cases Optional Equipment To answer telephone which does not ringTo silence an alarm on telephone To silence an alarm on sensorTo release door lock To enter an account number and dial To call an extension while talking with another extension To transfer an outside call to an extensionYou will bear the intercom dial tone from handset Dimensions Inch Heigh x Width x Depth, Weight Pound Page Receiving and Following Th?@i% ‘cr ‘-‘ Storing and Setting Press El one-touch key Ress Conf