Chapter 4 Configuring the ATA 187
Adding Users to Cisco Unified Communications Manager
Table
Parameter | Description | |
|
| |
Caller Disconnect Polarity | • User forward polarity while caller is disconnected | |
| • User reverse polarity while caller is disconnected | |
|
|
|
Caller ID | • | BT FSK |
| • | Bellcore FSK |
| • | ETSI FSK |
|
| |
Cisco Discovery Protocol (CDP) | Enable or disable the CDP function of the ATA 187 | |
|
| |
Fax Error Correction Mode Override | You can set the fax error correction mode override values to | |
| one of the following settings: | |
| • | Default |
| • | On |
| • | Off |
|
| |
Fax Mode | The Cisco ATA supports two fax modes: | |
| • Fax | |
|
| pass through a voice port |
| • T.38 Fax | |
|
| fax transmission over packet networks |
|
| |
Hookflash Timer | Hookflash Timer | |
(100 ms to 1500 ms) | The time to validate hookflash event | |
|
| |
Impedance | The ATA 187 provides multiple impedance values, such as | |
| 600 ohm for use in the United States | |
|
| |
Input Audio Level | Gain value of | |
|
| |
IVR Password | ATA187 IVR password | |
|
| |
Maximum Fax Rate | Indicates the maximum fax | |
|
| |
Offhook Validation Timer | Offhook Validation Timer | |
(100 ms to 1000 ms) | Indicates the time to validate an offhook event | |
|
| |
Onhook Delay Timer | ||
(0 ms to 155 ms) | Indicates the time to delay an onhook event | |
|
| |
Onhook Validation Timer | Onhook Validation Timer | |
| Indicates time to validate an onhook event | |
|
| |
Output Audio Level | Gain value of | |
|
| |
Web Access | Enable or disable web access on the ATA 187 | |
|
|
|
Adding Users to Cisco Unified Communications Manager
Adding users to Cisco Unified Communications Manager allows you to display and maintain information about users and allows each user to perform these tasks:
•Access the corporate directory and other customized directories from an ATA 187.
Cisco ATA 187 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
|
| |
|