Uniden DGA940 Cleaning the Battery Contacts, Setting the PULSE/TONE Switch, Low battery indicator

Page 19

Most phone systems use tone dialing. Check with your local phone company if you’re not sure whether your system is tone or pulse.

▼Low battery indicator

The low battery indicator shows when the battery pack is very low and needs to be charged. If the phone is not in use, the talk/batt low LED flashes every four seconds. If the phone is in use, the talk/batt low LED flashes every four seconds and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base for charging.

All rechargeable nickel-cadmium batteries develop a “memory effect”. The memory effect gradually reduces your talk and standby time.

▼To avoid Memory Effect

On a monthly basis, use the phone until the talk/batt low LED indicator flashes on the handset. Then charge the battery for 15-20 hours.

With normal usage, your battery should last about one year.

CLEANING THE BATTERY CONTACTS

To maintain a good charge, clean all charging contacts on the handset and base about once a month. Use a pencil eraser or other contact cleaner. DO NOT use liquids or solvents; you may damage your phone.

SETTING THE PULSE/TONE SWITCH

Be sure the PULSE/TONE switch

is in the TONE position, unless your local phone system uses pulse dialing.

16

Image 19

Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Before you read anything else, please observe the following PrecautionsPrecaution Do not short-circuit the batteryPrecautions Important Safety InstructionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Introduction FeaturesWelcome Included in Your Package Installation Considerations InstallingSet the base on a desk or tabletop with DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Initial battery charging Charging the Battery PackCharging optional battery pack With normal usage, your battery should last about one year Cleaning the Battery ContactsSetting the PULSE/TONE Switch Low battery indicatorBase ringer volume Adjusting Ringer ToneHandset ringer volume Handset earpiece volumeTo remove the beltclip Installing the BeltclipTo attach the beltclip Remove the slot coverAutomatic Digital Code Security Headset InstallationRestore power to the base To reset the digital security codeMaking and Receiving Calls UsingBasic phone operation Flash and Call Waiting If you are dialing in the pulse modeIf you have Call Waiting service and a ToneOne touch memory dialing Using the memory location featuresDialing a Number in Memory Remove the handset from the basePabx Connection Dial the party or service main numberChain Dialing Travelling OUT-OF-RANGEMessage counter LED turns off Integrated Answering DevicePress skip or repeat Setting the ClockYour message plays back for your review Preset messageFollowing message is pre-recorded Press and hold ogm until you hearSelecting the Message Time Setting the Ring TimeTo select a PIN Selecting a PIN CodeRepeating a Message Playing Your MessagesDeleting a Message Skipping a MessageSystem returns to Standby Using the Reset ButtonReset button is used to initialise the base computer Recording a Voice MemoRemote Switch On Remote Access Away from HomeRemote Room Monitor Function Press Other FunctionsQuick Reference Chart TroubleshootingFour minute option System does not Handset SpecificationsGeneral Base UnitWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ