Uniden DGA940 manual Installing, Installation Considerations

Page 11

INSTALLING

AND ADJUSTING YOUR PHONE

INSTALLATION CONSIDERATIONS

Selecting a Location

Before choosing a location for your new phone, here are some important guidelines you should consider:

The location should be close to both a phone jack and a power outlet.

Keep the base and handset away from sources of electrical noise such as motors and fluorescent lighting.

Be sure there is sufficient space to rotate the base antenna fully vertical.

The base can be placed on a desk, tabletop or mounted on a standard wall plate.

You should charge the battery in your handset for 15-20 hours before connecting the phone line.

Most phone equipment available now uses modular jacks. Phone cords are fitted with a molded plastic connector which plugs into this type of jack. If you do not have a modular phone jack, contact your local telephone company for information about their installation.

Connecting the Telephone Cords

Consider these safety guidelines before connecting the telephone cord.

Caution!

Never install telephone wiring during a lightning storm.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected.

Use caution when installing or modifying telephone lines.

8

Image 11
Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Before you read anything else, please observe the following PrecautionsPrecaution Do not short-circuit the batteryPrecautions Important Safety InstructionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Welcome FeaturesIntroduction Included in Your Package Installation Considerations InstallingSet the base on a desk or tabletop with DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Charging optional battery pack Charging the Battery PackInitial battery charging With normal usage, your battery should last about one year Cleaning the Battery ContactsSetting the PULSE/TONE Switch Low battery indicatorBase ringer volume Adjusting Ringer ToneHandset ringer volume Handset earpiece volumeTo remove the beltclip Installing the BeltclipTo attach the beltclip Remove the slot coverAutomatic Digital Code Security Headset InstallationRestore power to the base To reset the digital security codeBasic phone operation UsingMaking and Receiving Calls Flash and Call Waiting If you are dialing in the pulse modeIf you have Call Waiting service and a ToneOne touch memory dialing Using the memory location featuresDialing a Number in Memory Remove the handset from the basePabx Connection Dial the party or service main numberChain Dialing Travelling OUT-OF-RANGEMessage counter LED turns off Integrated Answering DevicePress skip or repeat Setting the ClockYour message plays back for your review Preset messageFollowing message is pre-recorded Press and hold ogm until you hearSelecting the Message Time Setting the Ring TimeTo select a PIN Selecting a PIN CodeRepeating a Message Playing Your MessagesDeleting a Message Skipping a MessageSystem returns to Standby Using the Reset ButtonReset button is used to initialise the base computer Recording a Voice MemoRemote Room Monitor Remote Access Away from HomeRemote Switch On Function Press Other FunctionsQuick Reference Chart TroubleshootingFour minute option System does not Handset SpecificationsGeneral Base UnitWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ