Uniden DGA940 manual Specifications, General, Base Unit, Handset

Page 39

SPECIFICATIONS

YOUR NEW PHONE

GENERAL

The DGA940 complies with TS001, TS002, TS004, AS/NNZS3260 and FCC Part 15 (as per ACA Radio Communications Class Licensing Requirements).

Frequency control: PLL

Modulation: Direct Sequence Spread Spectrum; DBPSK

Operating temperature: 0º to +50º C

BASE UNIT

Frequency: 917.4 to 925.8 MHz (15 channels)

Power requirements: 10V 500mA (from AC adaptor)

Size: 187mm (W) x 89mm (D) x 222mm (H)

Weight: Approx. 3.2kg (including optional battery)

Battery: BT-900 (as a back-up)

Capacity	600mAH, 3.6V
Talk mode	2 hours
Standby mode	4 hours

HANDSET

Frequency: 917.4 to 925.8 MHz (15 channels)

Power requirements: Rechargeable Nickel-Cadmium battery pack

Size (without antenna): 57mm (W) x 44.5mm (D) x 184mm (H)

Weight: Approx. 264g (including battery)

Battery:	BT-900
Capacity		600 mAH, 3.6V
Talk mode		4 hours
Standby mode		7 days

Specifications, features, and availability of optional accessories are all subject to change without prior notice.

36

Image 39

Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Before you read anything else, please observe the following PrecautionsPrecaution Do not short-circuit the batteryPrecautions Important Safety InstructionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Features IntroductionWelcome Included in Your Package Installation Considerations InstallingSet the base on a desk or tabletop with DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Charging the Battery Pack Initial battery chargingCharging optional battery pack With normal usage, your battery should last about one year Cleaning the Battery ContactsSetting the PULSE/TONE Switch Low battery indicatorBase ringer volume Adjusting Ringer ToneHandset ringer volume Handset earpiece volumeTo remove the beltclip Installing the BeltclipTo attach the beltclip Remove the slot coverAutomatic Digital Code Security Headset InstallationRestore power to the base To reset the digital security codeUsing Making and Receiving CallsBasic phone operation Flash and Call Waiting If you are dialing in the pulse modeIf you have Call Waiting service and a ToneOne touch memory dialing Using the memory location featuresDialing a Number in Memory Remove the handset from the basePabx Connection Dial the party or service main numberChain Dialing Travelling OUT-OF-RANGEMessage counter LED turns off Integrated Answering DevicePress skip or repeat Setting the ClockYour message plays back for your review Preset messageFollowing message is pre-recorded Press and hold ogm until you hearSelecting the Message Time Setting the Ring TimeTo select a PIN Selecting a PIN CodeRepeating a Message Playing Your MessagesDeleting a Message Skipping a MessageSystem returns to Standby Using the Reset ButtonReset button is used to initialise the base computer Recording a Voice MemoRemote Access Away from Home Remote Switch OnRemote Room Monitor Function Press Other FunctionsQuick Reference Chart TroubleshootingFour minute option System does not Handset SpecificationsGeneral Base UnitWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ