Uniden DGA940 manual Wall Installation, Standard wall plate mounting

Page 13

Place the power cord so that it does not create a trip hazard or where it could become chafed

and create a fire or electrical hazard.

Use only the Uniden AC adaptor supplied with this phone plugged to uninterrupted power supply.

WALL INSTALLATION

Standard wall plate mounting

This phone can be mounted on any standard wall plate.

1. Snap the desktop/wall mount adaptor into the bottom of the base as shown.

2. Plug the AC adaptor into the base.

3. Place the AC adaptor cord inside the molded wiring channel.

Wrap the cord around the strain relief notch.

4. Plug the AC adaptor into a standard

240V AC wall outlet.

5. Plug one end of the short telephone cord (not supplied) into the

TEL LINE jack on the back of the base. Plug the other end into a standard telephone jack.

10

Image 13
Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Precaution PrecautionsDo not short-circuit the battery Before you read anything else, please observe the followingPrecautions Important Safety InstructionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Introduction FeaturesWelcome Included in Your Package Installation Considerations InstallingSet the base on a desk or tabletop with DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Initial battery charging Charging the Battery PackCharging optional battery pack Setting the PULSE/TONE Switch Cleaning the Battery ContactsLow battery indicator With normal usage, your battery should last about one yearHandset ringer volume Adjusting Ringer ToneHandset earpiece volume Base ringer volumeTo attach the beltclip Installing the BeltclipRemove the slot cover To remove the beltclipRestore power to the base Headset InstallationTo reset the digital security code Automatic Digital Code SecurityMaking and Receiving Calls UsingBasic phone operation If you have Call Waiting service and a If you are dialing in the pulse modeTone Flash and Call WaitingDialing a Number in Memory Using the memory location featuresRemove the handset from the base One touch memory dialingChain Dialing Dial the party or service main numberTravelling OUT-OF-RANGE Pabx ConnectionMessage counter LED turns off Integrated Answering DevicePress skip or repeat Setting the ClockFollowing message is pre-recorded Preset messagePress and hold ogm until you hear Your message plays back for your reviewSelecting the Message Time Setting the Ring TimeTo select a PIN Selecting a PIN CodeRepeating a Message Playing Your MessagesDeleting a Message Skipping a MessageReset button is used to initialise the base computer Using the Reset ButtonRecording a Voice Memo System returns to StandbyRemote Switch On Remote Access Away from HomeRemote Room Monitor Function Press Other FunctionsQuick Reference Chart TroubleshootingFour minute option System does not General SpecificationsBase Unit HandsetWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ