Uniden DGA940 manual Setting the Clock, Press skip or repeat

Page 28

SETTING THE CLOCK

The clock on the DGA940 Answering System starts when power is applied to the base.

To set the correct time:

1. Press and hold clock until a tone sounds.

2.Press skip or repeat

until the correct day is announced. Numbers 0 through 6 display as each day is announced.

3.Press clock again to select the day. The hour setting is announced.

4.Press skip or repeat until you hear the current hour setting. Numbers 1 through 12 display as each hour is announced.

5.Press clock again to select the correct hour.

6.Press skip or repeat until

you hear the current minute setting. The numbers

0 through 59 display as each minute is announced.

7.Press clock again to select the correct minute. The AM/PM setting is announced.

8.The LED displays an A or P. Press skip or

repeat until you hear the correct AM/PM setting.

9.Press clock again to complete your settings.

The DGA940 Answering System announces the correct time.

ANSWERING DEVICE SET-UP

25

Image 28

Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Precautions PrecautionDo not short-circuit the battery Before you read anything else, please observe the followingImportant Safety Instructions PrecautionsAdditional Battery Safety Precautions Important Electrical ConsiderationsTelephone Line Problems Introduction FeaturesWelcome Included in Your Package Installing Installation ConsiderationsDESK/TABLETOP Installation Set the base on a desk or tabletop withWall Installation Standard wall plate mountingDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Initial battery charging Charging the Battery PackCharging optional battery pack Cleaning the Battery Contacts Setting the PULSE/TONE SwitchLow battery indicator With normal usage, your battery should last about one yearAdjusting Ringer Tone Handset ringer volumeHandset earpiece volume Base ringer volumeInstalling the Beltclip To attach the beltclipRemove the slot cover To remove the beltclipHeadset Installation Restore power to the baseTo reset the digital security code Automatic Digital Code SecurityMaking and Receiving Calls UsingBasic phone operation If you are dialing in the pulse mode If you have Call Waiting service and aTone Flash and Call WaitingUsing the memory location features Dialing a Number in MemoryRemove the handset from the base One touch memory dialingDial the party or service main number Chain DialingTravelling OUT-OF-RANGE Pabx ConnectionIntegrated Answering Device Message counter LED turns offSetting the Clock Press skip or repeatPreset message Following message is pre-recordedPress and hold ogm until you hear Your message plays back for your reviewSetting the Ring Time Selecting the Message TimeSelecting a PIN Code To select a PINPlaying Your Messages Repeating a MessageSkipping a Message Deleting a MessageUsing the Reset Button Reset button is used to initialise the base computerRecording a Voice Memo System returns to StandbyRemote Switch On Remote Access Away from HomeRemote Room Monitor Other Functions Function PressTroubleshooting Quick Reference ChartFour minute option System does not Specifications GeneralBase Unit HandsetWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ