Uniden DGA940 manual Preset message, Following message is pre-recorded

Page 29

RECORDING YOUR OUTGOING MESSAGE

When you receive a call, the answering system automatically plays either a preset greeting, or your own personal greeting.

▼Preset message

The following message is pre-recorded:

“Hello, no one is available to take your call. Please leave a message after the tone.”

▼Recording your personal Outgoing Message (ogm)

1. Press and hold ogm until you hear

a long tone. After the message counter LED blinks, release ogm. Record your message by speaking within 30 cm of the base microphone.

2.When you finish recording your message, press ogm again. A tone sounds.

Your message plays back for your review.

30cm

To choose between the pre-recorded greeting and your personal greeting, press ogm during outgoing message playback.

▼Announce Only feature

The Announce Only feature repeats a pre-recorded ogm - “No one is available to take your call”, or your own personal ogm. It will not allow the caller to leave a message.

For Announce Only, move the REC TIME switch to the ANN position.

The message counter LED displays

A when the system is on Standby

26

Image 29

Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Precaution PrecautionsDo not short-circuit the battery Before you read anything else, please observe the followingPrecautions Important Safety InstructionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Welcome FeaturesIntroduction Included in Your Package Installation Considerations InstallingSet the base on a desk or tabletop with DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Charging optional battery pack Charging the Battery PackInitial battery charging Setting the PULSE/TONE Switch Cleaning the Battery ContactsLow battery indicator With normal usage, your battery should last about one yearHandset ringer volume Adjusting Ringer ToneHandset earpiece volume Base ringer volumeTo attach the beltclip Installing the BeltclipRemove the slot cover To remove the beltclipRestore power to the base Headset InstallationTo reset the digital security code Automatic Digital Code SecurityBasic phone operation UsingMaking and Receiving Calls If you have Call Waiting service and a If you are dialing in the pulse modeTone Flash and Call WaitingDialing a Number in Memory Using the memory location featuresRemove the handset from the base One touch memory dialingChain Dialing Dial the party or service main numberTravelling OUT-OF-RANGE Pabx ConnectionMessage counter LED turns off Integrated Answering DevicePress skip or repeat Setting the ClockFollowing message is pre-recorded Preset messagePress and hold ogm until you hear Your message plays back for your reviewSelecting the Message Time Setting the Ring TimeTo select a PIN Selecting a PIN CodeRepeating a Message Playing Your MessagesDeleting a Message Skipping a MessageReset button is used to initialise the base computer Using the Reset ButtonRecording a Voice Memo System returns to StandbyRemote Room Monitor Remote Access Away from HomeRemote Switch On Function Press Other FunctionsQuick Reference Chart TroubleshootingFour minute option System does not General SpecificationsBase Unit HandsetWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ