3Com WXR100 3CRWXR10095A manual Resetting the STP Port Priority to the Default Value

356CHAPTER 17: CONFIGURING AND MANAGING SPANNING TREE PROTOCOL

Resetting the STP Port Priority to the Default Value

To reset the STP port priority to the default value, use one of the following commands:

clear spantree portpri port-list

clear spantree portvlanpri port-list{all vlan vlan-id}

The command applies only to the ports you specify. The port cost on other ports remains unchanged.

Changing the STP Port Priority

To change the priority of a port, use one of the following commands:

set spantree portpri port-listpriority value

set spantree portvlanpri port-listpriority value {all vlan vlan-id}

The set spantree portpri command changes the priority for ports in the default VLAN (VLAN 1) only. The set spantree portvlanpri command changes the priority for ports in a specific other VLAN or in all VLANs.

Specify a priority from 0 (highest priority) through 255 (lowest priority).

The default is 128.

The all option applies the change to all VLANs. Alternatively, specify an individual VLAN.

To set the priority of ports 3 and 4 in the default VLAN to 48, type the following command:

WX1200# set spantree portpri 3-4 priority 48 success: change accepted.

To set the priority of ports 3 and 4 to 48 in VLAN mauve, type the following command:

WX1200# set spantree portvlanpri 3-4 priority 48 vlan mauve success: change accepted.

Resetting the STP Port Priority to the Default Value

To reset the STP port priority to the default value, use one of the following commands:

clear spantree portpri port-list

clear spantree portvlanpri port-list{all vlan vlan-id}