3Com WXR100 3CRWXR10095A, WX4400 3CRWX440095A, WX1200 3CRWX120695A manual Countermeasures

580CHAPTER 26: ROGUE DETECTION AND COUNTERMEASURES

The following command displays an ignore list containing two BSSIDs:

WX4400# display rfdetect ignore Total number of entries: 2

Ignore MAC

-----------------

aa:bb:cc:11:22:33

aa:bb:cc:44:55:66

Enabling	Countermeasures are disabled by default. You can enable them on an
Countermeasures	individual radio profile basis. To enable countermeasures on a radio
	profile, use the following command:
	set radio-profile name countermeasures {all rogue
	configured none}
	The all option enables or disables countermeasures for rogues and for
	interfering devices. This option is equivalent to the scope of rogue
	detection in MSS Version 3.x. The rogue option enables or disables
	countermeasures for rogues only.
	The configured option causes radios to attack only devices specified in
	the attack list on the WX switch (on-demandcountermeasures). When
	this option is used, devices found to be rogues by other means, such as
	policy violations or by determining that the device is providing
	connectivity to the wired network, are not attacked.
	The none option disables countermeasures for this radio profile.
	The following command enables countermeasures in radio profile
	radprof3 for rogues only:
	WX4400# set radio-profile radprof3 countermeasures rogue
	success: change accepted.
	The following command causes radios managed by radio profile radprof3
	to issue countermeasures against devices in the WX switch’s attack list:
	WX4400# set radio-profile radprof3 countermeasures configured
	success: change accepted.
	To disable countermeasures on a radio profile, use the following
	command:

clear radio-profile name countermeasures