3Com WX4400 3CRWX440095A manual Resetting a Radio Profile Parameter to its Default Value

Configuring MAPs 245

The default preamble length value is short. This command does not apply to 802.11a radios.

To change the preamble length advertised by 802.11b/g radios, use the following command:

set radio-profile name preamble-length {long short}

To configure 802.11b/g radios that use the radio profile rp_long to advertise support for long preambles instead of short preambles, type the following command:

WX1200# set radio-profile rp_long preamble-length long success: change accepted.

Resetting a Radio Profile Parameter to its Default Value

To reset a radio profile parameter to its default value, use the following command:

clear radio-profile name parameter

The parameter can be one of the radio profile parameters listed in Table 12 on page 209.

Make sure you specify the radio profile parameter you want to reset. If you do not specify a parameter, MSS deletes the entire profile from the configuration.

All radios that use this profile must be disabled before you can delete the profile. If you specify a parameter, the setting for the parameter is reset to its default value. The settings of the other parameters are unchanged and the radio profile remains in the configuration. If you do not specify a parameter, the entire radio profile is deleted from the configuration.

To disable the radios that are using radio profile rp1 and reset the beaconed-ssidparameter to its default value, type the following commands:

WX1200# set radio-profile rp1 mode disable WX1200# clear radio-profile rp1 beaconed-ssid success: change accepted.

Removing a Radio Profile

To remove a radio profile, use the following command:

clear radio-profile name