3Com WX4400 3CRWX440095A, WXR100 3CRWXR10095A Display log buffer trace, Clear log buffer trace

	Configuring and Managing the System Log 625
Table 54 Event Severity Levels (continued)
Severity	Description
notice	Events that potentially can cause system problems have
	occurred. These are logged for diagnostic purposes. No
	action is required.
info	Informational messages only. No problem exists.
debug	Output from debugging.
	The debug level produces a lot of messages, many of which
	can appear to be somewhat cryptic. Debug messages are

used primarily by 3Com for troubleshooting and are not intended for administrator use.

Using Log Commands To enable, disable, or modify system logging to the WX switch’s log buffer, console, current Telnet session, or trace buffer, use the following command:

set log {buffer console current sessions trace} [severity severity-level] [enable disable]

To configure system logging to a syslog server, use the following command:

set log server ip-addr[port port-number]severity severity-level[local-facility facility-level]

To enable periodic mark messages for use in troubleshooting, use the following command:

set log mark [enable disable] [severity level] [interval interval]

To view log entries in the system or trace buffer, use the following command:

display log buffer trace

To clear log messages from the system or trace buffer, use the following command:

clear log buffer trace

To stop sending messages to a syslog server, use the following command:

clear log server ip-addr